Foxconn A7VML English Manual. - Page 43
► USB Storage Configuration
View all Foxconn A7VML manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
3 DOS mode. The available settings are: [High Speed] in 480Mbps; [Full Speed] in 12Mbps. ► Legacy USB Support This item is used to enable the support for USB devices on legacy OS. If you have a USB keyboard or mouse, set to auto or enabled. If USB devices are connected to the computer, the following item will appear: ► USB Storage Configuration After pressing , you can set the reset delay for the USB mass storage device. There are many different emulation types of this USB device, such as floppy, hard disk and CDROM can be selected. SuperIO Configuration CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc. SuperIO Configuration SuperIO Configuration Help Item OnBoard Floppy Controller Serial Port1 Address IR Address IR Mode IR Duplex Mode Parallel Port Address Parallel Port Mode [Enabled] Allows BIOS to enable [3F8/IRQ4] or disable floppy [2F8/IRQ3] controller. [IrDA] [Half Duplex] [378] [Normal] Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help F9:Optimized Defaults ► OnBoard Floppy Controller This item is used to enable/disable Floppy Controller. ► Serial Port1 Address This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial port 1. ► IR Address This item is used to assign the I/O address and interrupt request (IRQ) for the IR port. ► IR Mode This item is used to set the IR mode. The available settings are : [IrDA] : An IrDA device for maximum 115200 bit/s. [ASK IR] : A faster IrDA for 1152000 bit/s. ► IR Duplex Mode This item enables you to determine the infrared function of the onboard infrared chip. ► Parallel Port Address This item is used to assign the I/O address for the onboard parallel port . ► Parallel Port Mode 36