Frigidaire FAQE7021LW Product Specifications Sheet (English) - Page 3
Optional Accessories, Front Load Dryer Specifications - stack kit
UPC - 012505383403
View all Frigidaire FAQE7021LW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Frigidaire Affinity (All L Models excluding FAQE7021L) Front Load Dryers FAQE7021L B / W 7.0 Cu. Ft. Electric Front Load Dryer Specifications • Product Shipping Weight (approx.) - 140 Lbs. • An electrical supply with grounded three-prong receptacle is required. • Voltage Rating - 240V / 60 Hz / 30 Amps • Single phase 3- or 4-wire cable, 240 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line. (Do not use same circuit as washer.) • Connected Load (kW Rating) @ 240 Volts = 5.0 kW • Amps @ 240 Volts = 24 Amps • Dryer MUST employ a 3-conductor NEMA 10-30 type SRDT or 4-conductor NEMA 14-30 type SRDT or ST (as required), rated at 240 volt AC minimum, 30 amp power supply cord marked for use with clothes dryers (not supplied). • Grounding through neutral link prohibited in specific applications and certain locales, requiring use of 4-wire system. (For detailed electrical requirements, refer to Product Installation Guide on web.) • Always consult local and national electric codes. • Can be installed alone, with or without optional 15" Drawer Pedestal, or stacked above matching Frigidaire® Affinity Washer, which requires installation of optional Dryer Stacking Kit. (For installation details, refer to instructions included with optional pedestal or stacking kit or on web.) • Can be built in with matching Frigidaire® Affinity Washer in undercounter, recessed or closet installation. (Refer to Built-In Installations on this page for cutout dimensions. For additional installation details, refer to Product Installation Guide on web.) • Closet installation requires vented door with 2 unobstructed louvered openings, minimum 60 sq. in. each, located 3" from top and bottom of door. Full-length 120 sq. in. opening also acceptable. Allow additional 1" clearance between fronts of units and closed door. • Do NOT install in area exposed to dripping water or outdoor weather conditions; where gasoline or other flammables are kept or stored; or where dryer comes in contact with curtains, drapes or anything that will obstruct flow of combustion and ventilation air. • For garage installation, dryer MUST be located minimum 18" above floor. • Floor MUST be solid with 1" maximum slope. Do NOT install on carpeted surface. • Dryer MUST exhaust to outside of building, NOT into any concealed space. • Exhaust installation requires minimum 4"-diameter rigid or flexible metal duct with approved vent hood having swing-out damper(s). Do NOT use flexible plastic or metal foil duct and use shortest run possible. • Leveling legs supplied to level dryer properly and reduce excessive noise and vibration. Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions. Optional Accessories • Dryer Stacking Kit - (PN # STACKIT4X). • 15" Classic Black Drawer Pedestal - (PN # CFPWD15B). • 15" Classic White Drawer Pedestal - (PN # CFPWD15W). • Mobile Home Installation Kit - (PN # 137067200). • Drying Rack - (PN # 137067300). USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca FAQE7021L 10/10 © 2010 Electrolux Home Products, Inc. Specifications subject to change. Printed in the U.S.A.