Frigidaire FCRE3062AS Installation Instructions - Page 5
Installing Power Cords, United States
View all Frigidaire FCRE3062AS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
30" ELECTRIC REAR CONTROL FREESTANDING INSTALLATION INSTRUCTIONS 6. Installing Power Cords (United States) RISK OF FIRE OR ELECTRICAL SHOCK MAY OCCUR IF AN INCORRECT SIZE RANGE CORD KIT IS USED, THE INSTALLATION INSTRUCTIONS ARE NOT FOLLOWED OR STRAIN RELIEF BRACKET IS DISCARDED. This appliance may be connected by means of a power supply cord. Use a power supply cord kit rated at 125/250 volts minimum, marked for use with ranges. Access the Terminal Block 1. Remove the access cover and bracket from the back of the appliance. Keep all pieces and the screws. Fig. 9 Cord must have either three (3) or four (4) conductors. Terminals on end of wires must be either closed loop or open-end spade lugs with upturned ends. Required for new and remodeled installations 4-Wire Wall receptacle (14-50R) Allowed for existing installations 3 Wire Wall receptacle (10-50R) Fig. 10 Cord must have strain relief properly installed. Fig. 12 2. Pull the cord terminals through the correct hole in the bracket included with the appliance. 3. Connect the terminals to the terminal block as instructed for 3-wire, 4-wire, or permanent connections. See the next section for specific instructions for each connection. 4. Place the strain relief through the included bracket and tighten against the power cord. 5. Replace the bracket and access cover on the appliance. Fig. 13 Fig. 11 5