Frigidaire FEQ1442ES Operating Instructions - Page 3

ERROR CODE CHART If the dryer stops, the status lights flash and the signal beeps, an error has occured. Press PAUSE/CANCEL. Consult the Error Code Chart below or the "Avoid Service Checklist" in the Owner's Guide for the possible cause and solution. Make correction, then select a cycle and press START. If the dryer stops, status lights flash again and the beeping continues, please contact service for assistance. Error Code 4 beeps 6 beeps Error Dryer ran too long Push button does not function Possible Causes Solutions Lint filter blocked. Ventilation system clogged. Dryer overloaded. Remove lint; wash lint filter to remove softener sheet residue Clean out ventilation system. Reduce load size. Push button held too long or wedged in the control panel. Press buttons lightly and release. Disengage button. DRYER SETTINGS CHART These temperatures, dryness levels and options are available with the following cycles: Estimated Cycle Duration *** Towels 60 minutes Normal 50 minutes Perm Press 40 minutes Delicate 20 minutes Quick ** Touch Up ** Temperatures High Medium Low recommended No Heat not recommended not recommended not recommended not recommended Dryness Level More Dry * Normal Dry * * Less Dry * Damp Dry Options Press Saver Cycle Signal * Factory setting * * * * Available settings ** Timed Dry Cycle Only * * * * *** Estimated cycle duration is based on normal dryness level and factory settings. Timed Dry ** * PN 134420600C