Frigidaire FFAD3534W1 Complete Owners Guide - Page 13
Operating Instructions
View all Frigidaire FFAD3534W1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
13 OPERATING INSTRUCTIONS 3. After a few days when the Relative Humidity has declined, press the HUMIDITY ( ) or ( ) buttons to choose a value between 35% to 85%, so the room is kept at a comfortable humidity. Pressing the ( ) or ( ) buttons will change the humidity selection in 5% increments. 5 seconds after you have set the desired humidity, the readout will display the actual room humidity. If at any time you want to return to the CONTINUOUS Mode, pressing the HUMIDITY ( ) button will lower the Relative Humidity through 5% decrements until the display reads CO. 4. You can also use the FAN SPEED button to change the fan speed to Hi, Med or Lo. The indicator light will show the setting you have selected. A higher fan speed will result in quicker moisture removal. 6. The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 0.5 hour to 24 hours. If the unit is running, then selecting Timer will turn the unit o in the hours that will be set (Delay Stop). If the unit is o , then selecting Timer will turn the unit on in the hours that will be set (Delay Start). TIMER setting: First press TIMER button, then adjust timer setting, by tapping or holding the ( ) or ( ) button to change the delay timer at 0.5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. The control will count down the time remaining (8h, 7.5h, 7h etc.) until the unit either starts or stops. For the Delay Start, the fan speed and humidity maintained will be the same as previous setting. After TIMER setting finishes, pressing TIMER button again at any time will stop the TIMER function. The Delay Start/Stop Feature will work until the unit either starts or stops. Once that happens the above steps have to be repeated. 5. The Filter reset light will illuminate after 250 hours of operation. At this time refer to the care and cleaning section to remove and clean the filter. Once the filter has been cleaned and replaced, simply press the Filter reset button to extinguish the light. NOTE 1. Before entering TIMER setting, make sure power is being supplied to the unit. 2. Before entering TIMER setting, make sure pressing HUMIDITY ( ) or ( ) button sets one desired room humidity first. 7. To shut the unit down, press the ON/OFF button. Note: After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.