Frigidaire FFHI1832TS Wiring Diagram - Page 1

PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS AT MID-POINT CONTROL SETTING Capacitor Run or Induction Run 65°F (18°C) Ambient Operating Time 25 to 35% Freezer Temperature 2° to 8°F (-17° to -13°C) Refrigerator Temperature 35° to 40°F (2° to 4°C) Low Side Pressure (cut-in) 8 to 16 psig ( 55 to 110 kPa) Low Side Pressure (cut-out) 1 to 4 psig (7 to 28 kPa) High Side Pressure (last 1/3 cycle) 110 to 120 psig (758 to 827 kPa) Wattage (last 1/3 cycle) 95 to 140 Amps (running) 0.9 to 1.3 Base Voltage 115 vac (127 vac max) DEFROST SPECIFICATIONS Cabinet Size Thermostat Cut-in Cut-out Ohms 18', 20' & 21' 9°F (-2°C) 50°F (10°C) 35 15' & 16' 29°F (-2°C) 50°F (10°C) 41 Mechanical Timer - Defrost 24 minutes every 10 hours of compressor run time. Electronic Timer (ADC) - Defrost up to 24 minutes every 6-72 hours of compressor run time. CONDENSER FAN MOTOR Watts RPM 2.3 1100 CW Opposite Shaft ICE MAKER SPECIFICATIONS Electrical 115 vac (127 vac max) 60 Hertz Thermostat Ice maker with Opens at 52°F Closes at 12°F black housing (11°C) (-11°C) Ice maker with Opens at 48°F Closes at 9°F white housing (8.9°C) (-12.8°C) Heater Wattage 165 W ICE MAKER CONNECTOR PLUG CONNECTIONS Wire Number Wire Color 1 Green / Yellow 2 Yellow 3 Black 4 Light Blue SERVICE DATA SHEET A06813801 STANDARD - AUTOMATIC DEFROST TOP MOUNT FREEZER - R134a IMPORTANT SAFETY NOTE The information provided herein is designed to assist qualified repair personnel only. Untrained persons should not attempt to make repairs due to the possibility of electrical shock. Disconnect power cord before servicing this appliance. IMPORTANT If any green grounding wires are removed during servicing, they must be returned to their original position and properly secured. NOTE Some products come equipped with an Electronic Defrost Control. To initiate defrost, depress the fresh food light switch 5 times in 6 seconds (light bulb must be working). To terminate defrost, depress the fresh food light switch 5 times in 6 seconds. CAUTION All electrical parts and wiring must be shielded from torch flame. DO NOT allow torch to touch insulation; it will char at 200°F and flash ignite (burn) at 500°F. Excessive heat will distort the plastic liner. BLUE BLUE DK. BLUE BLUE BLUE YELLOW YELLOW IMPORTANT PLEASE RETURN THIS SHEET TO ITS ORIGINAL LOCATION. ICE MAKER INFORMATION Test Cycling: Remove cover by inserting screwdriver in notch at bottom and prying cover from housing. Use screwdriver to rotate motor gear counterclockwise until holding switch circuit is completed. All components of ice maker should function to complete the cycle. Water Fill Volume: The water fill adjustment screw will change the fill time. One full turn is equal to 20cc (.68 oz.). The correct fill is 102 to 130cc (3.4 to 4.3 oz.). When a water valve is replaced, the fill volume must be checked.