Frigidaire FFLE1011MW Installation Instructions - Page 10

Important, Warning

Page 10 highlights

INSTALLATION REQUIREMENTS Clearance requirements MINIMUM INSTALLATION CLEARANCES - Inches (cm) SIDES REAR TOP FRONT Alcove Closet 0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 1" (2.5 cm) 1" (2.5 cm) n/a 1" (2.5 cm) 1" (2.5 cm) 0" (0 cm) 0" (0 cm) 1" (2.5 cm) WARNING EXPLOSION HAZARD Do not install the dryer where gasoline or other flammables are kept or stored. If the dryer is installed in a garage, it must be a minimum of 18 inches (45.7 cm) above the floor. Failure to do so can result in death, explosion, fire or burns. IMPORTANT DO NOT INSTALL YOUR LAUNDRY CENTER: 1 In an area exposed to dripping water or outside weather conditions. The ambient temperature should never be below 60° F (15.6° C) to maximize detergent effectiveness. 2 In an area where it will come in contact with curtains, drapes, or anything that will obstruct the flow of combustion and ventilation air. 3 On carpet. Floor MUST be solid with a maximum slope of 1 inch (2.5 cm). To minimize vibration or movement, reinforcement of the floor may be necessary. Laundry Center Dimensions gas supply pipe on rear of gas unit 47.5" (120.5 cm) 17.6" (45 cm) water supply connection on rear of washer drain hose retention clamp on rear of washer2 9.4" (24 cm) 5.5" (14 cm) 76" (193 cm) power cord attachment location on rear of unit1 4 in. (102 mm) exhaust vent on rear of unit 12" (30.5 cm) 44" (112 cm) 54.75" (139 cm) 37" (94 cm) 27" (68.5 cm) 1Power supply cord length on gas unit approximately 60 inches (152.5 cm). 2Loose drain hose length beyond clamp approximately 52 inches (132 cm). 10 center line height for 4 in. (102 mm) exhaust outlet 42.5" (108 cm) 31.5" (80 cm)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64

10
Laundry Center Dimensions
47.5” (120.5 cm)
31.5” (80 cm)
27” (68.5 cm)
76”
(193 cm)
12”
(30.5 cm)
37”
(94 cm)
54.75”
(139 cm)
42.5”
(108 cm)
4 in. (102 mm)
exhaust vent
on rear of unit
center line height
for 4 in. (102 mm)
exhaust outlet
drain hose reten-
tion clamp on rear
of washer
2
water supply
connection on
rear of washer
power cord
attachment
location on rear
of unit
1
17.6”
(45 cm)
1
Power supply cord length on gas unit approximately 60 inches (152.5 cm).
2
Loose drain hose length beyond clamp approximately 52 inches (132 cm).
44”
(112 cm)
9.4”
(24 cm)
5.5”
(14 cm)
gas supply
pipe on rear
of gas unit
MINIMUM INSTALLATION CLEARANCES - Inches (cm)
SIDES
REAR
TOP
FRONT
Alcove
0”
(0 cm)
0”
(0 cm)
1”
(2.5 cm)
n/a
Closet
0”
(0 cm)
0”
(0 cm)
1”
(2.5 cm)
1”
(2.5 cm)
Clearance requirements
0”
(0 cm)
0”
(0 cm)
1”
(2.5 cm)
1”
(2.5 cm)
INSTALLATION REQUIREMENTS
IMPORTANT
DO NOT INSTALL YOUR LAUNDRY CENTER:
1
In an area exposed to dripping water or outside weather conditions. The ambient temperature should never
be below 60° F (15.6° C) to maximize detergent effectiveness.
2
In an area where it will come in contact with curtains, drapes, or anything that will obstruct the
ow of
combustion and ventilation air.
3
On carpet. Floor MUST be solid with a maximum slope of 1 inch (2.5 cm). To minimize vibration or movement,
reinforcement of the
oor may be necessary.
WARNING
EXPLOSION HAZARD
Do not install the dryer where gasoline or other
ammables are kept or stored. If the dryer is installed
in a garage, it must be a minimum of 18 inches (45.7
cm) above the
oor. Failure to do so can result in
death, explosion,
re or burns.