Frigidaire FFRE2533U2 Installation Instructions - Page 4
Place Cabinet in Window, Install Support Bracket
View all Frigidaire FFRE2533U2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Installation Instructions FIG.9 This side should face to indoor side "I" section Retainer Window Filler Panel FIG.10 Retainer "I" section 4 Place Cabinet in Window 1. Open window and mark the center of window inner sill as shown (FIG. 11). 2. Place cabinet in window with cabinet bracket securely seated over edge of inner sill as shown in FIG. 12. Bring window down temporarily behind top angle rail to hold cabinet in place. 3. Shift cabinet left or right as needed to line up center of cabinet on center line marked on inner sill. 4. For wooden window: Fasten cabinet to window inner sill with two 1/2" long hex head screws into holes (FIG.13A). (You may wish to pre-drill pilot holes.) For Vinyl-Clad window: Place two safety locks into the holes located in the bottom of the cabinet and drive two #10X1/4" pan-head Phillips locking screws through the safety locks into the cabinet as shown (FIG.13B). 5. Remove protective strip from adhesive side of Bottom Rail Foam Seal. Apply Seal over screws fastening bottom rail to window inner sill. FIG.12 Angle of cabinet bracket securely seated on edge of inner sill. FIG.13A 1/2" long HEX-HEAD SCREW A B FIG.13B FIG.11 cabinet window Bracket inner sill C window outer sill A. #10 X 1/4" pan-head Phillips screws 5 Install Support Bracket B. Safety Lock (Only for Vinly-Clad Window) C. Bottom Rail Foam Seal 1. Hold each support bracket flush against outside of sill and tight to bottom of cabinet. Mark brackets at top level of sill. Mark cabinet bottom at distance of sill width. See Fig. 15 A. Remove support brackets. 2. Attach sill angle brackets to support brackets at marked positions with flat head bolts and nuts. Hand tighten only at this point. See Fig. 15B. 3. Insert 1/2" long bolts through appropriate holes in cabinet bottom given the sill width distance. Thread the bolts into the slots of the support brackets. Tighten lock washer nuts onto bolts. 4. Adjust height of sill angle bracket so that bracket rests securely on edge of sill, and so that cabinet has about 1/8" to 1/4" downward tilt for proper water drainage (tilted about 2° to 4° downward to the outside, see Fig. 14). Tighten nuts securely. After proper installation, condensate should not drain from the overflow drain hole during normal use, correct the slope otherwise. FIG.14 Window Sash about 1/8" - 1/4" FIG.15B LEFT 1/2" LONG SCREWS AND LOCKNUTS LOCKNUT SILL ANGLE BRACKET RIGHT Side Louvers Sill Angle Bracket 4Window Sill 1/2" LONG SCREWS AND LOCKNUTS MARK FIG.15A MARK 3/4" FLAT HEAD BOLT 2 EACH REQ'D FOR EACH SUPPORT BRACKET