Frigidaire FFRH2522R2 Installation Instructions - Page 5

Installation Instructions 6 Extend Window Filler Panels and attach to top angle rail: 1. Carefully raise window to expose filler panel locking screws on top angle rail. Loosen screws so filler panels slide easily. 2. Extend panels to fill window opening completely. Tighten locking screws on top (FIG. 16). 3. Close window behind top angle rail. 4. $WWDFKWKHWRSDQJOHUDLOWRZLQGRZIUDPH8VHDƎGULOOELWWRGULOORQHKROHWKURXJKWKHKROHLQWKHPLGGOHRIWRS DQJOHUDLOLQWRWKHZLQGRZIUDPHDQGGULYHRQHƎHEX-HEAD locking screw through the hole in the middle of top angle rail into the window frame as shown (FIG. 17). FIG.16 FIG. 17 LOCKING SCREWS ƎLocking Screw and Washer ƎORQJ HEX-HEAD SCREW 7 Attach Window Filler Panels to Window Frame FIG. 18B 1. Extend the window filler panels out against the window frame. 2. Use a 1/8" drill bit to drill a starter hole through the hole in the top leg of each window filler panel and into the window sash (Fig. 18A and Fig. 18B). Connect with one 1/2" long hex head screw. C FIG. 18A Window Sash B A weather seals 8 Install Window Sash Seal and Safety Lock A 1. Trim window sash seal to fit window width. Insert it into space between upper and lower sashes as shown (FIG. 19). 2. Attach right angle safety lock to top window sash as shown (FIG.20). A. Ǝlong hex head screw B. left-hand Window Filler Panel Top Leg C. Window channel A. Ǝlong hex head screw 3. If necessary, trim weather seals to needed length, peel off protective backing, and use to plug any gaps. See Fig. 18B. FIG.19 FIG.20 FIG. 21 WINDOW SASH SEAL SAFETY LOCK ƎORQJ hex-head screws Vent control correct location 9 Install Air Conditioner into Cabinet and Install Front Panel to Unit 1. Lift air conditioner and carefully slide into cabinet. 2. CAUTION: Do not push on controls OR finned coils. 3. Be sure air conditioner is firmly seated towards rear of cabinet. 4. Reconnect electronics plug if present. Position vent control lever so that it will thread into its channel in the front panel (see FIG.21). Hook front panel top tabs into slots on cabinet top, and rotate front panel down so that side tabs snap into place on cabinet. Insert 4 previously removed screws through front panel and into air conditioner. 5. Insert air conditioner filter. Reinstall the front grille by hooking bottom tabs into slots on Front Panel bottom, then rotating grille up to snap into place. 5