Frigidaire FGET3066UF Product Specifications Sheet - Page 3

FGET3066U D/F DOUBLE WALL OVEN 30" ELECTRIC 30" 28 1/4" 1 1/2" min. 30 1/8" min. 50 3/4" (includes 1" bottom trim) Spacers 48 5/8" Power supply location (left bottom rear) 48 7/8" min. 50 1/4" max. 28 1/2" min. 29" max. 2"-wide wood spacers (if needed)** 24" min.* (critical dimension) Allow at least 21" clearance for door depth when open 24 3/4" 11 1/2" suggested distance 4 1/2" min. required *Critical dimension - MUST be applied **For cutout height greater than 50 1/4", add one 2"-wide worsaohidilms. of appropriate height Lifting oven will hide to each side larger cutout of opening opening at under oven side top and oven's 1"-high bottom trim will hide shims at bottom.(Optional 3"-high bottom trim available for cutout height greater than 501/4".) 2" min. 4" x 4" opening to route armored cable Full base required to support 375 lbs. 3" max. Electrical junction box location INSTALLATION SPECIFICATIONS • Product Shipping Weight (approx.) - 280 Lbs. • Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line. • Connected Load (kW Rating) @ 240 / 208 Volts = 9 / 6.8 kW • Amps @ 240 / 208 Volts = 37.5 / 32.7 Amps • Recommended Circuit Breaker - 40 Amps • Always consult local and national electric codes. • Minimum 21" clearance for oven door depth when open. • Suggested distance from floor is 11-1/2". Minimum required distance is 4-1/2". • Minimum 24" deep cutout dimension is critical for proper installation, to ensure that oven's faceplate will fit flush against cabinet front. • To adapt oven to fit cutout height greater than 50-1/4", add one 2"-wide wood shim of appropriate height to each side of opening under oven side rails. Lifting oven will hide larger cutout opening at top and oven's 1"-high bottom trim will hide shims at bottom. (Standard 1"-High Bottom Trim included.) • To adapt oven to fit cutout height greater than 49-7/8", optional 3"-High Bottom Trim available. • Full oven base of solid plywood or similar material required, capable of supporting 375 Lbs. • Base must be level and cabinet front must be square. • Double Wall Ovens are NOT approved to be used in stackable or side-byside installation. OPTIONAL ACCESSORIES • 3"-High Black Stainless Steel Bottom Trim - (PN #5304520624). • 3"-High Stainless Steel Bottom Trim - (PN #5304520627). • 10'-Long Armored Power Cable - (PN # 903056-9010). Note: For planning purposes only. Always consult local and national electric, gas and plumbing codes. Refer to Product Installation Guide for detailed installation instructions on the web at frigidaire.com / frigidaire.ca. Specifications subject to change. Accessories information available on the web at frigidaire.com / frigidaire.ca USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca FGET3066U 11/19 © 2019 Electrolux Home Products, Inc.