Frigidaire FGHS2367KP Use and Care Manual - Page 16
More about your Advanced Water Filter, Test & certification results, To replace your PureSource
UPC - 012505696770
View all Frigidaire FGHS2367KP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
CHANGING THE FILTER More about your Advanced Water Filter The PureSource UltraTM ice and water filter system is tested and certified by NSF International, to NSF/ANSI Standards 42 and 53 for the reduction of claims specified on the performance data sheet. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. Test & certification results: • Rated Capacity - 200 gallons/757 liters for PureSource UltraTM ice and water filter • Rated service flow - .50 gallons per minute • Operating Temp.: Min. 33°F, Max. 100°F • Maximum Rated Pressure - 100 pounds per square inch • Recommended Minimum Operating Pressure: 30 pounds per square inch To replace your PureSource UltraTM water filter: It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement. 1 Turn Off the ice maker. 2 Remove the filter by pushing on the end/face of the filter. 3 Slide the old water filter cartridge straight out of the housing and discard it. 4 Unpackage the new filter cartridge. Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing. 5 Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the snap-in connector). 6 Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal. 7 After filling one glass of water, continue flushing the system for about three minutes. 8 Turn On the ice maker. 9 Press and hold the Filter Status button on the Ice & Water Dispenser control panel for three seconds. When the display changes from "Replace" to "Good," the status has been reset. 16