Frigidaire FGID2476SF Complete Owner s Guide - Page 4

FEATURES AT A GLANCE Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms against soiled surfaces. First, the dishwasher drains for a few seconds to remove soils dropped while loading, then fills with water covering the filter area. Water is then pumped through the spray arms. Soil particles go through and across the filter and down the drain as the water is pumped out. This series of steps are repeated as needed. The number of water fills varies with the cycle being used. Features may vary according to model Upper Spray Arm Tub Gasket Cup Shelves Soft Grip Rack Middle Spray Arm Upper Rack Silverware Basket Lower Rack Lower Spray Arm Detergent Dispenser Rinse Aid Dispenser Filter Serial Label (located on right side of door) Operating Instructions Getting Started 1. Load Dishwasher (See Preparing and Loading Dishes). 2. Add detergent (See Dishwasher Dispenser & Detergents). 3. Add Rinse Aid, if needed (See Rinse Aid). 4. Run hot water faucet nearest dishwasher until water is hot. Turn water off. 5. Select desired CYCLE (See Cycle Chart). 6. Select desired OPTION (See Option Selections). 7. To start, press START/CANCEL pad and close door immediately. To Start a Cycle When cycle and options are selected, LEDs of selected cycle and options are illuminated. The status window displays the cycle time and then displays 'Press Start'. To start the cycle, press START/CANCEL pad and close the dishwasher door immediately. The status window displays 'Close door' after the START/CANCEL pad is pressed. A tone will sound indicating the cycle is successfully started after door is closed. 4