Frigidaire FGS365EB Use and Care Manual - Page 18

Care & Cleaning Removing and Replacing Storage Drawer with Extendible Glide (some models) To Remove Storage Drawer: 1. Open the drawer to the fully opened position. 2. Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Figure 1). 3. Pull the drawer away from the range. To Replace Storage Drawer: 1. Pull the bearing glides to the front of the chassis glide (See Figure 2). 2. Align the glide on each side of the drawer with the glide slots on the range. 3. Pushthedrawerintotherangeuntillevers"click"(approximately2").Pullthedraweropen again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3. This will minimize possible damage to the bearing glides. Left Glide Pull down latch with finger Latch Latch Pull up latch with finger Removing and Replacing Warm & Serve Drawer (some models) Right Glide Figure 1 Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warm & Serve drawer. To Remove Warm & Serve Drawer: Bearing Glide 1. Turn power off before removing the warm & Serve drawer. 2. Open the drawer to the fully opened position. 3. Locate glide lever on each side of drawer, pull up on the left glide lever and Figure 2 push down on the right glide lever (See Figure 1). 4. Pull the drawer away from the range. To Replace Warm & Serve Drawer: 1. Pull the bearing glides to the front of the chassis glide (See Figure 2). NOTE: The Warm & Serve Drawer will NOT operate while in the "Self-Clean" and "Oven Lockout" modes 2. Align the glide on each side of the drawer with the glide slots on the range. 3. Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3. This will minimize possible damage to the bearing glides. Changing Oven Light Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature will reduce lamp life. On some models an interior oven light will turn on automatically when the oven is opened.The oven light may be turned on when the door is closed by using the oven light switch located on the Electronic Oven control. The oven light bulb is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE. To Replace the Light Bulb: BE SURE OVEN IS COOL 1. Turn the power off at the main source. 2. Wear a leather-faced glove for protection against possible broken glass. 3. Replace bulb with a 40 Watt appliance bulb only. 4. For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield. Adjusting Your Oven Temperature For instructions on how to adjust the oven temperature refer to the electronic oven control guide. 18