Frigidaire FGSS2335TF Complete Owner s Guide - Page 23

Automatic Ice & Water Dispenser, Frigidaire Professional

Page 23 highlights

AUTOMATIC ICE & WATER DISPENSER FRIGIDAIRE PROFESSIONAL Priming the water supply system CAUTION For proper dispenser operation, recommended water supply pressure should fall between 30 psi and 100 psi. Excessive pressure may cause the system to malfunction. 1 Begin filling the system by pressing and holding a drinking glass against the water dispenser paddle. 2 Keep the glass in this position until water comes out of the dispenser. It may take about 1½ minutes. 3 Continue dispensing Dispenser (varies by model) water for about four minutes to flush the system and plumbing connections of any impurities (stopping to empty the glass as necessary).  NOTE The water dispenser has a built-in device that shuts off the water flow after three minutes of continuous use. To reset this shutoff device, simply release the dispenser paddle. Ice Maker and Storage Bin Capacity This ice maker should produce 2.5 to 3 pounds of ice per 24 hours, depending on usage conditions. Ice is produced at a rate of 10 cubes every 75 to 90 minutes. How much ice can be stored in the ice bin? When completely full, the bin in standard depth units will hold about 11 pounds of ice (total weight of ice and bin will be about 15 pounds). The bin in counter depth units will hold about 8.5 pounds of ice (total weight of ice and bin will be about 12 pounds). Turning the ice maker on and off Ice production is controlled by the ice maker's On/Off feature on the control panel. Pressing and holding the On/Off button toggles the ice maker On/Off. IMPORTANT Turning off the ice maker simply disables ice making. You will still be able to dispense existing ice, and you will still be able to dispense water.  NOTE The ice maker also has a built-in plastic signal arm that automatically stops ice production when the ice bin is full. This signal arm should not be used to manually stop the ice maker.  NOTE Dispensed water is not chilled. For colder water, add ice to cup or container before dispensing water. Ice maker operation & care After the refrigerator is installed properly and has cooled for several hours, the ice maker can produce ice within 24 hours. The ice maker will fill the ice bin from the rear. You must dispense some ice to force the ice forward in the bin. This will allow the bin to fill completely. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39

23
IMPORTANT
Turning off the ice maker simply disables
ice making. You will still be able to dispense
existing ice, and you will still be able to
dispense water.
AUTOMATIC ICE & WATER DISPENSER
NOTE
The water dispenser has a built-in device that
shuts off the water flow after three minutes
of continuous use. To reset this shutoff
device, simply release the dispenser paddle.
NOTE
The ice maker also has a built-in plastic
signal arm that automatically stops ice
production when the ice bin is full. This
signal arm should not be used to manually
stop the ice maker.
CAUTION
For proper dispenser operation, recommended
water supply pressure should fall between
30 psi and 100 psi. Excessive pressure may
cause the system to malfunction.
Priming the water supply system
Ice maker operation & care
After the refrigerator is installed properly and
has cooled for several hours, the ice maker can
produce ice within 24 hours. The ice maker will
fill the ice bin from the rear. You must dispense
some ice to force the ice forward in the bin.
This will allow the bin to fill completely.
Ice Maker and Storage Bin
Capacity
This ice maker should produce 2.5 to 3 pounds
of ice per 24 hours, depending on usage
conditions. Ice is produced at a rate of 10
cubes every 75 to 90 minutes.
How much ice can be stored in
the ice bin?
When completely full, the bin in standard
depth units will hold about 11 pounds of ice
(total weight of ice and bin will be about 15
pounds). The bin in counter depth units will
hold about 8.5 pounds of ice (total weight of
ice and bin will be about 12 pounds).
Turning the ice maker on and off
Ice production is controlled by the ice maker’s
On/Off feature on the control panel. Pressing
and holding the On/Off button toggles the ice
maker On/Off.
NOTE
Dispensed water is not chilled. For colder
water, add ice to cup or container before
dispensing water.
1
Begin filling the system by pressing and
holding a drinking glass against the water
dispenser
paddle.
2 Keep the
glass
in this
position
until water
comes
out of the
dispenser.
It may
take
about 1½
minutes.
3 Continue
dispensing
water for about four minutes to flush the
system and plumbing connections of any
impurities (stopping to empty the glass as
necessary).
Dispenser
(varies by model)
FRIGIDAIRE PROFESSIONAL