Frigidaire FMP330RGB Complete Owner's Guide (English) - Page 9

Care and Cleaning Burn Hazard Allow heating element to cool before cleaning the interior. Failure to do so can result in burns. Outside-Occasionally wash with a mild nonabrasive detergent and water. Rinse and dry. Inside-The inside of the dishwasher is self- cleaning with normal use. To clean stainless steel wipe with the grains. Use a Dishwasher Safe Detergent to help with the stains or discolorations. NEVER use products that contain Chlorine Bleach or Citric Acid. Important: The dishwasher motor is permanently lubricated at the factory and does not need to be oiled. Care of Drain Air Gap If a drain air gap was installed for your built-in dishwasher, check to make sure it is clean so the dishwasher will drain properly. Drain air gaps are usually mounted on countertop and can be inspected by removing the cover. A drain air gap is not part of your dishwasher and is not covered by this warranty. Winterizing A dishwasher left in an unheated place should be protected from freezing. Have a qualified person do the following: To Disconnect Service: 1. Turn off electrical power to the dishwasher at the supply source by removing fuses or tripping circuit breaker. 2. Shut off water supply. 3. Place a pan under the inlet valve. Disconnect water line from inlet valve and drain into pan. 4. Disconnect drain line from pump and drain water into pan. Note: See Installation Instructions for more details. To Restore Service: 1. Reconnect the water, drain, and electrical power supply. 2. Turn on water and electrical power supply. 3. Fill both detergent cups and run dishwasher through a NORMAL WASH Cycle. 4. Check connections to make sure they do not leak. Note: See Installation Instructions for more details. Ci 9