Frigidaire FRT21S6JS Use and Care Guide - Page 8
To Remove Doors
UPC - 012505677182
View all Frigidaire FRT21S6JS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
DOOR REMOVAL / REVERSAL INSTRUCTIONS TO REMOVE REFRIGERATOR HANDLE: (Handles may be easier to reverse while doors are off.) Figure 1 Style Handles 1. Remove two screws attaching handle to top of refrigerator door. 2. Remove screw attaching bottom of handle to door. 3. Remove two hole plugs and hinge pin plug on top of door and install on opposite side. Use Phillips head screwdriver to remove plastic screw plug from front of door and install on opposite side Figure 2 Style Handles 1. Remove two screws attaching handle to top of refrigerator door. 2. Swing top of handle away from door and slide handle down and off of dovetail button. 3. Remove screw and dovetail button and install on other side, moving hole plugs from corresponding holes to opposite side. TO ATTACH REFRIGERATOR HANDLE: TO ATTACH TRIM: 1. Slide both trim locks out of trim. 2. Insert new adhesive trim locks contained in your literature pack. NOTE Trim lock must be removed and installed by sliding over the two donut shaped areas. 3. Install trim to handle by sliding under base of handle. Carefully align trim and press down at trim lock locations. 4. Use rubbing alcohol to remove any adhesive residue from old trim lock locations. Figure 1 Style Handles 1. Secure bottom of handle with screws. 2. Secure top of handle with screws. Figure 2 Style Handles 1. Start with handle offset away from door. Place bottom of handle over dovetail button, swing handle into an upright position and pull upward, locking it into place. 2. Secure top of handle with screws. TO REMOVE REFRIGERATOR HANDLE: (Handles may be easier to reverse while doors are off.) 1. Remove two screws attaching handle to top of refrigerator door. 2. Remove button plug using edge of putty knife. 3. Remove screw on side of refrigerator door and remove handle. 4. Reverse freezer and refrigerator handles as shown in figure 3. Figure 3 - Handle Reversal TO ATTACH REFRIGERATOR HANDLE: 1. Secure side of handle to door and replace plug button. 2. Secure handle to top of door. Refrigerator Door Without Trim Figure 1 Figure 2 REMOVING STAINLESS STEEL DOORS AND HANDLES CAUTION Use care when using tools near surface of stainless steel doors to avoid scratching. To Remove Doors Stainless steel doors are not reversible. Follow these steps to remove doors. 1. Remove toe grille and top hinge cover. 2. Remove top hinge and lift freezer door off of center hinge pin. Set door aside. 3. Unscrew center hinge pin using adjustable wrench and save for reassembly. Ensure plastic washer stays on Typical Handle hinge pin. 4. Lift refrigerator door off of bottom hinge and set aside. 5. Remove center hinge and shim by removing inside screw and loosening two outside screws enough to allow hinge to slide out. (continued on next page) 8