Frigidaire GLHT188WHB Installation Instructions - Page 1

TO BE REMOVED BY THE CUSTOMER AFTER INSTALLATION IS COMPLETE INSTALLATION CHECKOFF LIST Doors Door seals completely to cabinet on all sides Freezer door is level across the top Leveling Refrigerator is level, side to side and tilted 1/4" (6mm) front to back Toe grille is properly attached to refrigerator Cabinet is setting solid on all corners Electrical Power House power turned on Refrigerator plugged in Ice Maker House water supply connected to refrigerator No water leaks present at all connections - recheck in 24 hours Ice Maker is turned ON. Final Checks Shipping material removed Fresh Food and Freezer controls set Crisper Humidity controls set Registration Card sent in (Vea el otro lado para la versin español.) Refer to your Owner's Use and Care Manual for additional information about your refrigerator. Tools You Will Need: Phillips™ head Socket Wrench Set Adjustable Wrench OR 3/8" Fixed Wrench 1 HAND TRUCKING 2 SHIPPING MATERIAL 3 • Load refrigerator from side of cabinet only. • Do not run retaining straps over handles. • Do not over-tighten retaining straps. • Never use refrigerator handles to move the refrigerator. • Remove tape from doors only after unit is in place. qÜe water îalîe on tÜe baÅâ of tÜe refrigerator will CliÅâL_uòò if tÜe water îalîe is Ålosed. e äáåÉ t _e Åertain tÜe water îalîe is oéen and tÜere are no leaâs. WATER SUPPLY 4 INSTALLATION CLEARANCES Allow the following clearances for ease of installation, proper air circulation, and plumbing and electrical connections: • Sides & Top..........3/8" • Back 1" NOTE: If you are installing your refrigerator beside a wall, leave 1/2" minimum between hinges and wall to allow for the door to swing open. 7 8 Ensure icemaker is turned ON. Remove Shipping material. (Features may vary per model.) Connect water supply - check for water leaks. Turn icemaker OFF if water supply is not connected immediately. Connecting to a reverse osmosis system is not recommended. 5 LEVELING AND ADJUSTING All four corners of refrigerator must rest firmly on a solid floor.Your refrigerator has adjustable rollers to help level it and to adjust the doors. To level cabinet or change door height: 1. Remove toe grille. 2. Use a screwdriver, 3/8" wrench, or nutdriver to adjust the rollers. To raise cabinet , turn screw clockwise. To lower cabinet, turn screw counterclockwise. Cabinet Toe Grille 6 When changing CONTROLS, wait 24 hours before making additional adjustments. Top Hinge Cover Top Hinge Cable Bottom Hinge Water Tube Wood Block Shim Pin Center Hinge If you need to remove the doors to get your refrigerator into the house please see "Door Removal Instructions" in your Use & Care Guide. 9 √ See "Normal Operating Sights & Sounds" in the Use & Care Manual so you understand the sounds you may hear once your refrigerator is running. √ Please read entire Use & Care Manual to become aware of important safety instructions and to become familiar witrh your new refrigerator. √ Send in Registration card to register your refrigerator. √ Congratulations! You are ready to enjoy your new refrigerator. IF YOU ARE DISSATISFIED WITH THE INSTALLATION, PLEASE CALL THE STORE YOU PURCHASED IT FROM. P/N: 241567800