Frigidaire GLTF2940FB Installation Instructions

Frigidaire GLTF2940FB - Front Load Washer Manual

Frigidaire GLTF2940FB manual content summary:

  • Frigidaire GLTF2940FB | Installation Instructions - Page 1
    Electrical Requirements Grounding Requirements Water Supply Requirements Drain Requirements Rough-In Dimensions Location Of Your Washer Unpacking Installation Replacement Parts PAGE 2 2 2 2 2 3 4 4 4-6 6 Installation and service must be performed by a qualified installer, service agency or the gas
  • Frigidaire GLTF2940FB | Installation Instructions - Page 2
    is the owner's responsibility to have a licensed electrician replace it with a properly grounded three prong grounding type receptacle. WATER SUPPLY REQUIREMENTS Hot and cold water faucets MUST be installed within 42 inches (107 cm) of your washer's water inlet. The faucets MUST be 3/4 inch (1.9 cm
  • Frigidaire GLTF2940FB | Installation Instructions - Page 3
    ROUGH-IN DIMENSIONS 3
  • Frigidaire GLTF2940FB | Installation Instructions - Page 4
    pull them out. 12. Remove and discard the yellow ribbon from the front of the washer. 13. Replace the service panel and screws. NOTE: If the washer is to be transported at a later date, the shipping support hardware must be reinstalled to prevent shipping damage. Drain Hose Installation The drain
  • Frigidaire GLTF2940FB | Installation Instructions - Page 5
    other inlet hose (90° elbow end) to the inside "C" outlet of the water valve. Tighten by hand, then tighten another 2/3 turn with pliers. Do front service panel. NOTE: Keep the leg extension at a minimum to prevent excessive vibration. The farther out the legs are extended the more the washer will
  • Frigidaire GLTF2940FB | Installation Instructions - Page 6
    's Guide before calling for service. 13. Place these instructions in a location near the washer for future reference. NOTE: A wiring diagram and technical data sheet are located in an envelope attached to the left hand side panel on the inside of the washer. REPLACEMENT PARTS If replacements parts
  • Frigidaire GLTF2940FB | Installation Instructions - Page 7
    Code ANSI/NFPA 70, ou au Canada, le Code canadien d'électricité, ACNOR C22.1, partie 1. Pour votre sécurité, suivre les directives données dans le présent guide téléphone d'un voisin. Suivre les instructions de la compagnie de gaz. · technicien qualifié, un agent de service ou la compagnie de gaz.
  • Frigidaire GLTF2940FB | Installation Instructions - Page 8
    présent guide afin de le téléphone d'un voisin. Suivre les instructions de la compagnie de gaz. · S'il les codes et ordonnances locaux ou, s'il n'existe pas de codes locaux, conformément au Code ANSI/ chaude et l'eau froide de 10 lb/po²). Le service des aqueducs de votre localité peut vous aider à
  • Frigidaire GLTF2940FB | Installation Instructions - Page 9
    DIMENRSOIOUGNHS -DINE LD'EIMMEPNLASICOENMSENT po (cm) Cordon d'alimentation Côté Boyau d'évacuation po (cm) Robinets d'arrivée d'eau Arrière 3
  • Frigidaire GLTF2940FB | Installation Instructions - Page 10
    laveuse sur son panneau arrière. 3. Retirer la base en styrofoam. 4. Replacer délicatement la laveuse à la verticale, puis retirer le carton. 5. Déplacer la machine à laver doit être transportée à une date ultérieure, il faut réinstaller la quincaillerie d'expédition, les attaches et supports, pour
  • Frigidaire GLTF2940FB | Installation Instructions - Page 11
    repose solidement sur le plancher, sans osciller. Pour les installations sous le comptoir, l'ajustement des pieds arrières est accessible par le panneau de service avant. Tourner les contreécrous de chaque pied vers le bas de la laveuse et serrer solidement avec une clé. REMARQUE : Garder les pieds
  • Frigidaire GLTF2940FB | Installation Instructions - Page 12
    . 10. Lire la Notice de fonctionnement et le Guide de l'utilisateur qui accompagnent la laveuse. Ces documents machine à laver, communiquez avec le numéro sans frais de Service et pièces de Frigidaire Company Authorized Parts Distributor, 1-800-944-9044, ou visitez notre website , www.frigidaire
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

Installation
Instructions
Full Size Tumble Action Washers
Before beginning installation, carefully read these instructions. This will simplify the
installation and ensure the
washer is installed correctly and safely. Leave these instructions
near the washer after installation for future reference.
NOTE: The electrical service to the washer must conform with local codes and ordinances
and the latest edition of the National Electrical Code, ANSI/NFPA 70.
Contents
SUBJECT
PAGE
Pre-Installation Requirements
2
Electrical Requirements
2
Grounding Requirements
2
Water Supply Requirements
2
Drain Requirements
2
Rough-In Dimensions
3
Location Of Your Washer
4
Unpacking
4
Installation
4-6
Replacement Parts
6
Printed in U.S.A.
P/N 134374600
A
(0411)
For your safety the information in
this manual must be followed to minimize the risk
of fire or explosion or to prevent property damage,
personal injury or loss of life.
-
Do not store or use gasoline or other flammable
vapors and liquid in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS
·
Do not try to light any appliance.
·
Do not touch any electrical switch; do not
use any phone in your building.
·
Clear the room, building or area of all
occupants.
·
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas suppliers
instructions.
·
If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.