Fujitsu E8210 E8210 User's Guide - Page 68

E8210.book Page 58 Friday, March 10, 2006 4:33 PM LifeBook E8000 Notebook Problem Possible Cause Possible Solutions The built-in display is blank when you turn on your LifeBook notebook. (continued) The display angle and brightness settings are not adequate for your lighting conditions. Move the display and the brightness control until you have adequate visibility. Pressing either the [F6] or [F7] keys while holding down the [Fn] key also allows you to change the brightness level of the display. The power management timeouts may be set for very short intervals and you failed to notice the display come on and go off again. Press a keyboard button or move the mouse to restore operation. If that fails, push the Power/Suspend/ Resume button. (The display may be shut off by Standby mode, Auto Suspend or Video Timeout) The notebook turned on with a series of beeps and the built-in display is blank. Power On Self Test (POST) has detected a failure which does not allow the display to operate. Contact your support representative. The display goes blank by itself after you have been using it. The notebook has gone into Video timeout, Standby mode, Suspend mode or Save-to-Disk mode because you have not used it for a period of time. Press any button on the keyboard, or move the mouse to restore operation. If that fails, push the Power/Suspend/ Resume button. Check your power management settings, or close your applications and go to the Power Savings menu of the setup utility to adjust the timeout values to better suit your operation needs. (See BIOS Setup Utility on page 29 for more information) The power management timeouts may be set for very short intervals and you failed to notice the display come on and go off again. Press any button on the keyboard, or move the mouse to restore operation. If that fails, push the Power/Suspend/ Resume button. (The display may be shut off by Standby Mode, Auto Suspend or Video Timeout) Something is pushing on the Closed Cover switch. Check the Closed Cover switch. (See figure 2-3 on page 6 for location) Your display won't turn on The system may be passwhen the system is turned word-protected. on or when it has resumed. Check the status indicator panel to verify that the Security icon is blinking. If it is blinking, enter your password. The Built-in Display does not close. A foreign object, such as a Remove all foreign objects from the keyboard. paper clip, is stuck between the display and keyboard. The Built-in Display has bright or dark spots. If the spots are very tiny and few in number, this is normal for a large LCD display. This is normal; do nothing. If the spots are numerous Display is faulty; contact your support representative. or large enough to interfere with your operation needs. The application display uses only a portion of your screen and is surrounded by a dark frame. You are running an application that does not support 800 x 600/1024 x 768 pixel resolution display and display compression is enabled. Display compression gives a clearer but smaller display for applications that do not support 800 x 600/1024 x 768 pixel resolution. You can fill the screen but have less resolution by changing display compression settings, (See Video Features submenu located within the Advanced menu of the BIOS. (See BIOS Setup Utility on page 29 for more information) 58