Garmin 010-10680-50 USB Data Card Programmer - Page 12

To Install a Garmin Data Card: 1. Insert the Data Card (Label up and pin connector end first) into the card slot in the Programmer (standard USB Programmer pictured to the right). , For the Mini-USB Programmer, make sure the Garmin globe logo on the Programmer is facing UP for proper orientation. 2. Be certain to install the Data Card completely into the slot to be sure the pin connections have been made. 3. To remove the Data Card, pull directly away from the Programmer using the extractor handle on the Data Card. , Use care not to remove the Data Card from the Programmer until data transfer has been completed to avoid possible loss of data. Disconnecting the Programmer from Your Computer After the USB Data Card Programmer has been successfully installed (hardware and software), disconnecting and reconnecting the Programmer can performed without additional installation steps. 1. Before disconnecting the Programmer, be certain that no data transfer is in progress. 2. Unplug the USB connector from your computer. You do not need to turn the computer off before removing or inserting the USB connector. Installation Installing a Data Card in the Programmer Extractor Handle Disconnecting the Programmer from Your Computer 5