Garmin Edge 305CAD Quick Start Guide - Page 2

Set Your Profiles To set your user profile: 1. Press mode to access the Main Menu. 2. Select Settings > User Profile. 3. Specify your Gender, Birth Date, and Weight using the arrows and the enter button. To set your bike profile: 1. Press mode to access the Main Menu. 2. Select Settings > Bike Profile. 3. Specify your Bike profile (configure up to three bikes) and Weight. 4. If you are using a GSC10, select Sensor Mounted. Then you can specify Wheel Size and Tire Size. May 2006 190-00580-01 Rev. D Printed in Taiwan Install the Heart Rate Monitor The Edge 305 with heart rate includes a wireless heart rate monitor that you wear directly on your skin, just below the breastplate. To position the heart rate monitor: 1. Push one tab on the strap through the slot in the heart rate monitor. Press the tab down. sensors 2. Wet both sensors on the back of the heart rate monitor to create a strong connection between your pulse and the transmitter. Quick Reference Guide Edge™ 205/305 GPS-enabled computer for cyclists 3. Place the heart rate monitor directly on your skin, just below the breastplate. Wrap the strap around your chest and attach the strap to the other side of the heart rate monitor. 4. Adjust the strap so it stays in place during your ride. 5. When positioned correctly, verify that your Edge is receiving data. The heart rate icon changes from flashing to constant . If not, go to Main Menu > Settings > System > Accessories to activate your heart rate monitor or restart scan. For more information about the heart rate monitor, refer to the owner's manual. Garmin Training Center™ Use the Garmin Training Center software on your personal computer to plan your advanced workouts and courses before you ride and analyze them afterwards. Install Garmin Training Center from the installation disk in the product box. For help using Garmin Training Center, click the Help menu in the software or press F1 on your keyboard. Install the GSC10™ Sensor The Edge 305 with cadence includes a wireless speed and cadence sensor. Both magnets must be aligned with their respective indication line and be within 5 mm of the GSC10 for the Edge to receive data. 1. Place the GSC10 on the rear chain stay (the side opposite of the drive train). Loosely attach the GSC10 using two cable ties. 2. Attach the pedal magnet to the crank arm using the adhesive mount and a cable tie. Make sure the indication line on the pedal magnet lines up with the indication line on the GSC10. 3. Unscrew and attach the spoke magnet. Make sure it is aligned with the sensor arm indication line. 4. Unscrew and move the GSC10 sensor arm to within 5 mm of the spoke magnet. 5. Press the Reset button on the GSC10. The LED turns red, then green. Pedal to test the sensor alignment. The red LED blinks each time the crank arm passes the sensor, and the green LED blinks each time the wheel magnet passes the sensor arm. 6. When everything is aligned and working correctly, tighten the cable ties, sensor arm, and spoke magnet. For more information about the GSC10, see the owner's manual. 1 GSC10 on rear chain stay indication line reset button 2 Pedal magnet on crank arm cable tie indication line cable ties 3 Spoke magnet on wheel spoke magnet pedal magnet sensor arm indication line