Garmin GHS 10 Wired VHF Handset Installation Instructions - Page 2
GHS 10/10i Installation Instructions
View all Garmin GHS 10 Wired VHF Handset manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
GHS 10/10i Installation Instructions These installation instructions are for the GHS 10 and GHS 10i handsets. The GHS 10 is for use with the Garmin VHF 200 radio and the GHS 10i is for use with the Garmin VHF 200i radio. For additional information, refer to the VHF 100/200 Series Radio Installation Instructions that came with your radio. For operational instructions, refer to your VHF 100/200 Series Radio Owner's Manual. The handset comes with a 32.8 ft. (10 m) extension cable, a bulkhead mounting plate, a weather cap, and the necessary cable hardware. To connect the GHS 10 or GHS 10i handset: 1. Using the mounting plate as a template, use a center punch to mark the three screw locations on the surface. 2. Use a pencil to trace the cable hole in the center of the mounting plate. Set the mounting plate aside. 3. Use a ⅞ in. (22 mm) hole saw to cut the cable-mounting hole. 4. Use a ⅛ in. (3 mm) drill to drill the three mounting-plate holes. Cable-mounting hole Install the GHS 10 or GHS 10i handset at least 20 in. (500 mm) from any compass. External speaker wires Mounting plate GHS 10/10i Installation Instructions Weather cap Cable nut EN-