Garmin GMR 404/406 Radar Pedestal GMR 404/406 Owner's Manual - Page 13

VRM/EBL The (Variable Range Marker (VRM) and Electronic Bearing Line (EBL) tools measure range and bearing to a target. You can move the center point of the VRM, which allows you to measure from one target to another. Two VRM/EBL tools can be active at the same time. The VRM/EBL option has two areas, VRM/EBL 1 and VRM/EBL 2. Each area has two settings, Show (Hide) and Adjust. Variable Range Marker(VRM) Electronic Bearing Line (EBL) Basic Operation > Radar Page You can adjust the diameter of the VRM and the angle of the EBL. To adjust the VRM/EBL: 1. Highlight Adjust and press the ROCKER to the right. Highlight Adjust and press ENTER. 2. Press right or left on the ROCKER to rotate the EBL around the center point of the VRM. 3. Press up or down on the ROCKER to increase or decrease the size of the VMR. 4. Press ENTER to accept the changes. To move the center location of the VRM: 1. Highlight Move, and press ENTER. 2. Using the ROCKER, move the center point of the VRM to the selected location. 3. Press ENTER to set the new location. To use the VRM/EBL, expand the diameter of the VRM so that the outer edge touches the target. Rotate the EBL until it intersects the VRM at the target location. The measured range and bearing are displayed in the lower-left corner of the screen. To start VRM/EBL 1 or VRM/EBL 2: On the Radar Adjustment menu, highlight Show VRM/EBL 1 or VRM/EBL 2, and then press ENTER. GMR 404/406 Owner's Manual