Garmin GMR Fantom Radars Installation Instructions - Page 4
Installation Troubleshooting
View all Garmin GMR Fantom Radars manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Contacting Garmin Support • Go to support.garmin.com for help and information, such as product manuals, frequently asked questions, videos, and customer support. • In the USA, call 913-397-8200 or 1-800-800-1020. • In the UK, call 0808 238 0000. • In Europe, call +44 (0) 870 850 1241. © 2016 Garmin Ltd. or its subsidiaries Garmin® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. GMR™ and Fantom™ are trademarks of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin. Item GMR Fantom 18 233 mm (9 3/16 in.) 227.5 mm (8 15/16 in.) 141.5 mm (5 9/16 in.) 139.2 mm (5 1/2 in.) GMR Fantom 24 233 mm (9 3/16 in.) 296.2 mm (9 11/16 in.) 141.5 mm (5 9/16 in.) 207.7 mm (8 3/16 in.) Open-Source Software License To view the open-source software license(s) used in this product, go to developer.garmin.com/open-source/linux/. Installation Troubleshooting Symptom The radar does not turn on. The status LED is not on. The radar is not available on the Garmin device or on devices connected to the Garmin Marine Network. Possible Causes • The power cable may not be connected correctly to the device or to the battery. Check all connections. • The inline fuse may have blown. Check the fuse and replace it if necessary. • The wire gauge used to extend the power cable may be too small for the length of the extension. Check the table provided in the Power Cable Extensions section of these instructions to make sure the correct wire gauge is used (Power Cable Extensions, page 3). • The radar may not be powering on. Check the status LED. • The device software may not be up-to-date. Update the software on the device or on the Garmin Marine Network. • The network cable may not be connected correctly to the device or to the Garmin Marine Network. Check all connections. • If a field-installable network connector was used, it may have been installed improperly. Check the connector. The status LED is located on the product label, and can help troubleshoot installation problems. Status LED Color Radar Status and Activity Solid red The radar is getting ready for use. The LED should be solid red briefly and change to flashing green. Flashing green The radar is operating properly. Flashing orange The radar software is being updated. Flashing red The radar has encountered an error. Contact Garmin product support for assistance. © 2016 Garmin Ltd. or its subsidiaries support.garmin.com