Garmin GPSMAP 740/740s Installation Instructions - Page 7
Updating the Chartplotter Software, Configure, System, System Information.
View all Garmin GPSMAP 740/740s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Identifying the Rear-Panel Connectors After the power/data cable is wired to the boat (and after any optional Garmin radar, NMEA 0183, NMEA 2000, or external GPS devices are installed) connect the cables to the GPSMAP 700 series chartplotter. Note: You must install the locking rings before connecting the power/data cable or a Garmin radar cable to the chartplotter (page 4). To connect a cable to the back of a GPSMAP 700 series chartplotter: 1. Carefully press the cable into the correct port on the back of the chartplotter until it is firmly seated. Do not force the cable, because this may damage the pins. 2. After the cable is seated, turn the locking ring clockwise until it is tight. Be careful not to overtighten the locking ring. ➊ ➋ ➌ ➍ GPSMAP 700 Series Connectors ➊ NMEA 2000 connector ➋ Radar port ➌ Power/data connector ➍ External GPS antenna connector Updating the Chartplotter Software The GPSMAP 700 series chartplotter may contain a software update SD card. If so, follow the instructions provided with the card. If a software update SD card is not included, visit www.garmin.com to make sure your chartplotter software is up-to-date. To identify the version of software on your chartplotter, select or touch Configure > System > System Information. GPSMAP 700 Series Installation Instructions