Garmin PT 10 Dog Device PRO 70/PRO 550 Owner's Manual - Page 6

Pro 70 Dog Collar Device Specifications Battery type Battery life Operating temperature range Charging temperature range Storage temperature range (up to 1 month) Storage temperature range (up to 3 months) Water rating Rechargeable, replaceable lithium-ion 60 hours typical use From -4° to 140°F (from -20° to 60°C) From 32° to 104°F (from 0° to 40°C) From -4° to 122°F (from -20° to 50°C) From -4° to 95°F (from -20° to 35°C) 1 ATM* *The device withstands pressure equivalent to a depth of 10 meters. Checking the Battery Level Turn on the dog collar device (Turning On the Dog Collar Device). The status LED flashes every few seconds while the device is on. The color of the status LED indicates the battery charge level. Green The battery has a good charge. Yellow The battery should be charged soon. Red The battery is very low and should be charged immediately. Flashing Red The battery is depleted and must be charged. Training features are disabled. Pro 70 Battery Replacement Instructions WARNING This product contains a lithium-ion battery. To prevent the possibility of personal injury or product damage caused by battery exposure to extreme heat, store the device out of direct sunlight. Do not use a sharp object to remove batteries. CAUTION Contact your local waste disposal department to properly recycle the batteries. Pro 70 Handheld Device Components Replacing the Pro 70 Handheld Device Battery Before you replace the battery, you must remove all dirt, water, and debris from the device. You also need a small Phillips screwdriver and the security screwdriver included with the battery replacement kit. You can purchase a replacement battery at http: / / buy .garmin .com. You should use only an official Garmin® replacement part. 1 Remove the eight security screws from the back of the device. 2 Lift up the back plate. 3 Grip the battery connector wires close to the connector, and pull the connector perpendicular to the circuit board to disconnect the battery connector from the device. 4 Grip the rotary switch connector wires close to the connector, and pull the connector perpendicular to the circuit board to disconnect the rotary switch connector from the device. 5 Remove the two screws from the battery plate. 6 Lift up the battery plate. 7 Remove the old battery from the back plate, noting the orientation of the battery. The battery fits tightly. It may be necessary to pry the battery out of the back plate using a non-sharp, non-metal object. 8 Install the new battery into the back plate with the label side up, using the same orientation as the old battery. The battery orientation is noted graphically inside the back plate. 9 Replace the battery plate to its original position. 10 Replace and tighten the battery plate screws. 11With the new battery, connect the battery connector to the device. When properly installed, the connector plug snaps into the port. 12 Reconnect the rotary switch connector to the device. When properly installed, the connector plug snaps into the port. 13Verify the gasket is not damaged and is completely seated in the groove on the front half of the device. 14While ensuring the battery and rotary switch wires are not pinched, hold the back plate and the device firmly together, and replace all eight security screws without tightening. 15Verify the back plate and the device are aligned with no gaps. 16 Tighten the screws evenly. 17 Verify the gasket is not sticking out of the device. Security screws À Back plate Á Battery plate screws  Gasket à Battery plate Ä Battery Å 4 Device Information