Garmin eTrex Legend C Quick Reference Guide - Page 2

Operating the eTrex Legend Operating the eTrex Legend 1 Installing the Batteries 3 Start Up Sequence The eTrex Legend operates on two AA batteries (not included), which are placed in the back of the unit. Rechargeable Alkaline, NiMH, NiCad or Lithium batteries may be used, but cannot be charged in the unit. Stored data will not be lost when changing the batteries. To install the batteries: 1. Remove the battery cover from the back of the unit by turning the D-ring 1/4 turn counter-clockwise and pulling out. 2. Insert the batteries observing proper polarity as shown at the right. 3. Reinstall the battery cover by turning the Dring 1/4 turn clockwise. D-Ring Slot for Carry Lanyard Attachment Battery Cover To turn the unit On: 1. Press and hold the POWER button. 2. Press the PAGE button to acknowledge the copyright. 3. Carefully read the warning message and press the PAGE button to acknowledge and proceed to the Satellite Page. The unit may take up to 5 minutes to establish a position the first time you use it outside with a clear view of the sky. After that, it should take only 15 to 45 seconds. When the Legend has acquired enough satellite signals to determine your location, a "Ready To Navigate" message and your location coordinates and elevation are shown. Satellite Page: displaying Satellite Position, Signal Strength, Location, and Elevation 2 Using the Button Functions The ZOOM IN and OUT buttons: • When on the Map Page, press to Zoom in and out. • When on the Satellite Page, press to adjust the screen contrast. The FIND button: LEGEND The PAGE button: • Press to cycle through main pages. The POWER button: • Press and hold to turn the unit On/Off. • Press to toggle the backlighting On/Off. • Press to access the Find Menu. The THUMB STICK: (When moved or pressed in, button 'clicks') • Press to enter highlighted options or confirm messages. • Move Up/Down or Right/Left to move through lists, highlight fields, on-screen buttons, icons, enter data or move the map panning arrow. • Press in and hold for two seconds to mark your current location as a waypoint. LCD Display External Power and Data Connector Protective Cover Connector Indexing (Alignment) Bar NOTE: While designed to be held and operated in the left hand, the unit can be used with the right hand, if preferred. The Main Pages, Setting the Time Zone 4 Previewing the Main Pages All of the information you need to operate the eTrex Legend is found on the five Main Pages (or display screens). To preview these pages, press the PAGE button to cycle from one page to the next. The five pages are shown in order below. Satellite Page Map Page Navigation Page Trip Computer Main Menu Satellite Page - Provides a visual reference of satellites being tracked. Map Page - Displays your movements and nearby map features. Navigation Page - Provides guidance to your destination. Trip Computer - Provides a variety of trip and navigation data. Main Menu - A directory of advanced features and settings. 5 Setting the Time Zone If the Legend is "Ready to Navigate" (Step 3) but the time shown is not correct, you may need to change the Time Zone selection. To change the Time Zone: 1. Use the PAGE button to access the Main Menu. 2. Use the THUMB STICK to highlight the SetUp icon and then press it in to display the SetUp Menu. 3. Use the THUMB STICK to highlight the Time icon and then press it in to display the Time Page. 4. Use the THUMB STICK to highlight the 'Time Zone' field then press it in to display the list of time 5. Highlight a time zone and then press the THUMB STICK. 6. The correct time is displayed at the bottom of the page. Backlighting/Contrast Adjustment Adjusting Backlight/Contrast POWER Button To turn the backlight On and Off: 1. Press the POWER button to turn the backlight On. 2. Press again to turn the backlight Off. 3. If no button is pressed (after 15 seconds*), the backlight will turn Off automatically. ZOOM IN and OUT Buttons To adjust the screen contrast: 1. Use the PAGE button to access the Satellite Page. 2. Use the ZOOM IN and OUT buttons to adjust the contrast. *To set the backlight feature for longer On Time, refer to the Owner's Manual. Additional Map Data Available You can transfer optional detailed map data to the eTrex Legend from a GARMIN MapSource® CD-ROM. Available choices include the MetroGuide, Points of Interest (Businesses, Landmarks, Cities, and Marine navaids), BlueChart™, Fishing Hot Spots, Topographic maps, Roads and Recreation, and WorldMap mapping guides. See your Owner's Manual for connection details. Points of Interest List Map Showing Resturant Choice