Gateway DX440X 8512418 - Gateway Reference Guide - Page 63
four screws to secure the power supply to the case.
View all Gateway DX440X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
www.gateway.com 6 Remove the eight system board screws. Screws Screws 7 Lift the system board up and out of the case. 8 Align the new system board on the screw holes in the case, then secure it into the case with the screws. 9 If your replacement system board does not include a processor remove the processor from the old system board by following the directions in "Replacing the heat sink and processor" on page 49, then install it and the heat sink into the new system board by following the directions in the same procedure. 10 Slide the power supply back into the case, then install the four screws to secure the power supply to the case. 11 Connect all power and data cables using your notes from Step 4. 12 Reinstall any memory modules you removed previously. 13 Reinstall any expansion cards you removed previously. 14 Replace the side panel by following the instructions in "Replacing the side panel" on page 37. 55