Gateway NV-53 Service Guide - Page 66
Replacing the multimedia board, Tools you need to complete this task:, Screws removed during
View all Gateway NV-53 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
CHAPTER 3: Replacing notebook components Replacing the multimedia board Tools you need to complete this task: Phillips #0 screwdriver Flat screwdriver or Non-marring plastic scribe Screws removed during this task: • 3 black M2.5×6 (keyboard cover) To replace the multimedia board: 1 Complete the steps in "Preparing the notebook" on page 47. 2 Remove the keyboard cover by performing steps 2-6 of the "Replacing the keyboard cover" procedure on page 58. Caution The multimedia board is glued to the keyboard cover. Remove this board only if it is defective. 3 Insert a small flat-blade screwdriver or non-marring scribe between the multimedia board and the keyboard cover's underside, and carefully pry the board loose. 4 Remove the multimedia board from the keyboard cover. Note A circuit board that is >10 cm2 has been highlighted with a yellow rectangle as shown in the above image. Follow the local regulations for disposing this type of circuit board. 60