Gateway NV-53A Service Guide - Page 95
Replacing the cooling assembly, Tools you need to complete this task:, Additional materials you need - replacement fan
View all Gateway NV-53A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
www.gateway.com Replacing the cooling assembly Tools you need to complete this task: Phillips #0 screwdriver Flat screwdriver or Non-marring plastic scribe Additional materials you need to complete this task: • Soft cloth and isopropyl alcohol; or alcohol pad • Thermal grease Screws removed during this task: • 1 black M2×5 (hard drive) • 1 black M2.5×6 (optical drive) • 3 black M2.5×6 (keyboard cover) • 2 black M2.5×6 (LCD panel hinge - bottom) • 2 black M2.5×6+Nylok (LCD panel hinge - top) • 10 M2.5×6 black (palm rest - base side) • 3 M2.5×6 black (palm rest - top side) • 1 black M2×4 (system board) To replace the cooling assembly: 1 Complete the steps in "Preparing the notebook" on page 47. 2 Remove the system board by performing steps 2-10 of the "Replacing the system board" procedure on page 86. 3 Turn the system board over to access the cooling fan cable. 4 Disconnect the cooling fan cable from its system board connector. 89