GE 24922 Instruction Manual - Page 8

Programming Your Remote, cont. Auto Code Search The Auto Code Search searches automatically through all of the codes stored in this remote. Read all the following steps prior to starting the auto search as you will need to be prepared to lock-in the proper code when found. 1. Manually turn on the device you wish to control. 2. Press and hold the SETUP button until the red indicator light stays on (approximately 4 seconds) and then release the button. 3. Press and release the desired device button on the remote (TV, DVR, CBL, DVD, SAT, AUX). The red indicator will blink once and then remain on. 4. Point the remote at the device and press and release the POWER button (for TV) or PLAY button (for DVD, VCR, etc.) to start the search. The red indicator will flash (approximately every 2 seconds) as the remote searches. Note: The remote must be pointed at the device for the duration of this search. 5. Place your finger on the #1 button so you are prepared to lock-in the code. 6. When the device shuts off or begins playing, press the #1 button to lock-in the code. The red indicator light will turn off. Note: You have approximately two seconds after the device shuts off or begins playing to lock-in the code. 7. Point the remote at the device and check to see if the remote operates the device as desired. If it does, no further programming is required for that device. If it does not, return to step 2 and start the auto search again. 8