GE AJEH12DC Owners Manual - Page 9

Fan Switch To reach tile tim switch (es) remove tile front grille. On HeagCool and Heat Pump models, tile tim switch leveI_ are located in holes accessed through tile control box. Tile top switch is fin" COOL settings and tile bottom sMtch is fin" H_lTsettings. Use a small screwdriver to change tile setting. Tile trait is shii)ped fl'Oll/ tile ti_ctory set ill tile CONY setting tot COOLand in tile cgCtfsetting tot HEAT Cool only models have a rocker switch on tile front of tile control box. _4qlen set at CYCLE (down) tile tim cycles on and off when cooling. When set at CONT (continuous, up) tile tim runs all tile time, providing a more balanced telnI)eramre. Tile unit is shipped ill tile CONTsetting. vvww.GEAppliances.com Temperature Limiting Limiting tile maMmum and minimum settings prevents useI_ ti'oln turning tile control to tile extrelne heat or cool positions. Tile nom/al range of tile temp control is approxinmtely 60°F to 85°E Tile control range may be narrowed by tile use of tile telni)erature lilniting screws located behind the control panel. Vent Control Tile vent control is located behind tile fl'ont grille on tile fight side of tile air discharge area. X'_qlell set at CLOSE,onl} tile air inside tile room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside. To open or close tile vent: 1. Relnove tile fl'ont grille. 2. Relnove tile vent card screw. 3. Relnove vent card, turn it over and replace it by locating rear hole in card over locating pin inside air dischmge and ream_ching scFew at Ji'ollt. . %. Limits@ heat temp Limits cool temp Each position equals approximately 3°E Ti_eunit leavesthefactorysetat the CLOSEposition. _hole OPENposition (Meshendtowardhack) Screwhc CLOSEposition (Meshendtoward front) A# Direction HolJzontnl lo/wei_ on tile fl'ont grille let you control tile air direction up and down. Reln_we tile fl'ont grille to a(!iust the vertical louve_ side-to-side to direct the air lett or fight.