GE AJEM12DCD Use and Care Manual - Page 18
Installation Instructions, WINDOW INSTALLATION-OPTIONAL cont., INSTALL SILL SUPPORTS, PREPARE WINDOW
View all GE AJEM12DCD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Installation Instructions WINDOW INSTALLATION-OPTIONAL (cont.) 4 PREPARE WINDOW A Mark the centerline of the stool. Measure from the centerline 133⁄8″ on both sides for the panel cuts. B Measure 123⁄8″ from the centerline on both sides for the sill support brackets. Centerline Sill Outside 133⁄8″ Stool 133⁄8″ Inside Sill Centerline Outside 123⁄8″ Stool 123⁄8″ Inside 5 INSTALL SILL SUPPORTS A Assemble the sill supports. Do not fully tighten the spacer mounting screws at this time. Type B Type E Sill support Spacer mounting screws Type (A) Spacer Lock nut Adjusting bolt Large washer (for use with wood sills) C Turn the bolts and tighten the lock nuts to make the sill supports level or tilt down 1/8″ to the outside. Line up the "V" notch with 123⁄8″ marks. Drill pilot holes and attach the sill supports. Average sill Spacer Sill support Narrow sill Offset sill (such as brick or stone) B Before attaching the sill supports, place them on the window stool. Select the spacer position that will place the spacer near the outermost point on the sill. Tighten the spacer mounting screws. Screws are in position Sill support "V" notch Inside Stool NOTES: • On narrow sills, there may not be enough room to use the lock nut. • A deep offset sill may require a longer adjusting bolt than the standard hex-head bolt provided. • On wood sills use the large washer between the bolt head and the sill. This prevents the bolt from digging into the wood. Sill Bolt Outside 18