GE AJES12DCC Owners Manual - Page 18
Window Installation-optional Cont., Install Sill Supports, Prepare Window
View all GE AJES12DCC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Installation Instructions WINDOW INSTALLATION-OPTIONAL (cont.) 4 PREPARE WINDOW A Mark the centerline of the stool. Measure from the centerline 133⁄8″ on both sides for the panel cuts. Centerline Sill Outside Stool 133⁄8″ 133⁄8″ Inside B Measure 123⁄8″ from the centerline on both sides for the sill support brackets. Sill Centerline Outside Stool 123⁄8″ 123⁄8″ Inside 5 INSTALL SILL SUPPORTS A Assemble the sill supports. Do not fully tighten the spacer mounting screws at this time. Type B Type E Sill support Spacer mounting screws Type (A) Spacer C Turn the bolts and tighten the lock nuts to make the sill supports level or tilt down 1/8″ to the outside. Line up the "V" notch with 123⁄8″ marks. Drill pilot holes and attach the sill supports. Average sill Spacer Sill support Narrow sill Lock nut Adjusting bolt Large washer (For use with wood sills) Offset sill (such as brick or stone) B Before attaching the sill supports, place them on the window stool. Select the spacer position that will place the spacer near the outermost point on the sill. Tighten the spacer mounting screws. Screws are in position NOTES: • On narrow sills, there may not be enough room to use the lock nut. • A deep offset sill may require a longer adjusting bolt than the standard hex head bolt provided. • On wood sills use the large washer between the bolt head and the sill. This prevents the bolt from digging into the wood. Sill support "V" notch Stool Sill Bolt 18