GE CVM1750SHSS Installation Instructions - Page 17

Installation Instructions 5 Roll the blower unit 90° so that fan blade openings are facing out the back of the oven. Before Rolling After Rolling 8 Replace the blower plate in the same position as before with the screws. Blower Plate Screws Blower Plate Back of Oven Back of Oven Back of Oven 6 Locate the two "knockout" plates, on the rear oven panel, near the top of the oven. Using tin snips, carefully cut the web area from the two holes side-by-side (that secure the knockouts to the oven). Cut all four webs on both rear knockouts; this will allow the ventilation fan airflow to exhaust out the rear of the oven. CAUTION: Be sure to trim the sharp edges from the openings after removing the knockout plates. Oven Rear Panel Snip all 4 webs on each knockout panel and remove the metal knockouts for rear airflow. 7 Place the blower unit back into the opening. AFTER: Fan Blade Openings Facing Back End A End B WARNING: Risk of electric shock can cause injury or death. Do not pull or stretch the blower unit wiring. make sure the wires are not pinched.. NOTE: The blower unit exhaust openings should match exhaust openings on rear of microwave oven. 9 Insert the tabs on each side of the damper into the holes at the inside rear of the adaptor. Exhaust Adaptor 10 Attach the exhaust adaptor to the rear of the oven by sliding it into the guides at the top center of the back of the oven. Exhaust Adaptor Damper (hinge side up) Slide exhaust adaptor into guides on oven rear. Screws Locking Back of Oven Tabs Guides Push in securely until it is in the lower locking tabs. Take care to assure the damper hinge is installed so that it is at the top and that the damper swings freely. 11 Secure the exhaust adaptor to the oven with the two bronze metal screws provided. 17