GE DSXH47EGWW Owners Manual - Page 15
Mobile Home Installation, Rough-in Dimensions
UPC - 084691158943
View all GE DSXH47EGWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Installation Instructions MOBILE HOME INSTALLATION 1. Dryer MUST be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4″ (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. 2. If the dryer is exhausted through the floor, the exhaust system MUST NOT terminate beneath the mobile home. Termination MUST be securely fastened to the mobile home structure. 3. When installing a gas dryer into a mobile home, a provision must be made for outside make-up air. This provision is to be not less than twice the area of the dryer exhaust outlet. 4. Gas dryers MUST be fastened to the floor using Mobile Home Installation Kit Pub. No. 14-D346-33. 5. See the Exhaust System Checklist section for other important venting information. 6. Installation MUST conform to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or, when such standard is not applicable, with American National Standard for Mobile Homes, ANSI/NFPA No. 501B. Correct Do ROUGH-IN DIMENSIONS Electrical supply on rear of unit 2 1/4″ (5.7 cm) Gas supply pipe on rear of unit 36″ (91.4 cm) 13 1/2″ 2 3/8″ (34.3 cm) (6.03 cm) To rear and base exhausts 27″ (68.6 cm) FRONT VIEW 48 1/2″ (123.2 cm) to clear open door Incorrect Don't Don't Don't The dryer is designed under ANSI Z 21.5.1. 5″ (12.7 cm) Center line height for rear, right, left vent 28 1/2″ (72.4 cm) 4 3/8″ (11.1 cm) to side exhausts 5 7/8″ (14.9 cm) to base exhaust 27 1/4″ (69.2 cm) to front of cabinet 27 3/4″ (70.5 cm) to clear knobs 28 1/2″ (72.4 cm) to clear door handle SIDE VIEW SERVICING - Consideration must be given to provide adequate clearances for installation and servicing. 15