GE GE50T06AAG Use and Care Manual - Page 6
Thermal Expansion, Typical Installation, Water Supply Connections - anode
View all GE GE50T06AAG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Operating Instructions Installation Instructions Safety Instructions Installing the water heater. Thermal Expansion Determine if a check valve exists in the inlet water line. It may have been installed in the cold water line as a separate back flow preventer, or it may be part of a pressure reducing valve, water meter or water softener. A check valve located in the cold water inlet line can cause what is referred to as a "closed water system". A cold water inlet line with no check valve or back flow prevention device is referred to as an "open" water system. As water is heated, it expands in volume and creates an increase in the pressure within the water system. This action is referred to as "thermal expansion". In an "open" water system, expanding water which exceeds the capacity of the water heater flows back into the city main where the pressure is easily dissipated. A "closed water system", however, prevents the expanding water from flowing back into the main supply line, and the result of "thermal expansion" can create a rapid and dangerous pressure increase in the water heater and system piping. This rapid pressure increase can quickly reach the safety setting of the relief valve, causing it to operate during each heating cycle. Thermal expansion, and the resulting rapid and repeated expansion and contraction of components in the water heater and piping system can cause premature failure of the relief valve, and possibly the heater itself. Replacing the relief valve will not correct the problem! The suggested method of controlling thermal expansion is to install an expansion tank in the cold water line between the water heater and the check valve (refer to the illustration below). The expansion tank is designed with an air cushion built in that compresses as the system pressure increases, thereby relieving the over pressure condition and eliminating the repeated operation of the relief valve. Other methods of controlling thermal expansion are also available. Contact your installing contractor, water supplier or plumbing inspector for additional information regarding this subject. Water Supply Connections NOTICE: Do not apply heat Refer to the illustration below for suggested typical installation. The installation of to the HOT or COLD water unions or flexible copper connectors is recommended on the hot and cold water connections. If sweat connections so that the water heater may be easily disconnected for servicing if connections are used, necessary. The HOT and COLD water connections are clearly marked and are 3/4″ NPT sweat tubing to adapter on all models. Install a shut-off valve in the cold water line near the water heater. before fitting adapter to the water connections on heater. Any heat applied to the water supply fittings will permanently damage the dip tube and/or heat traps. Typical Installation Vacuum Relief Valve (Not Supplied) Temperature and pressure relief valve Union To electrical distribution panel Heat trap 6″ minimum To cold water If required, install per local codes and valve manufacturer's instructions. Union R E L VAL I EF V E COLD HOT supply Shut-off valve Thermal expansion tank (if required) Heat trap 6″ minimum Anode Electrical junction box (use only copper conductors) Hot water outlet to fixtures Jacket access panel Care and Cleaning Troubleshooting Tips Customer Service Relief valve discharge line to suitable open drain 6 6″ air gap Jacket access panel Auxiliary catch pan 2″ maximum Drain valve