GE GFDS175EHDG Installation Instructions - Page 15
Side Or Bottom Venting
View all GE GFDS175EHDG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Installation Instructions SIDE OR BOTTOM VENTING Dryer Exhaust to right of cabinet for Electric models only. Dryer Exhaust to left of cabinet for Gas and Electric models. Dryer Exhaust to the bottom of cabinet for Gas and Electric models. WARNING - Fire Hazard Close the back opening with cover plate (Kit WE1M454). Disconnect dryer from electrical supply. Wear gloves and arm guards. Failure to do so may result in fire, electrical shock or lacerations. Remove screw and save Right (electric models only) Left Bottom Remove desired knockout (one only) Detach and remove the right (electric models only), left or bottom knockout as desired. Remove the screw inside the dryer exhaust duct and save. Pull the duct out of the dryer. Fixing hole A 13 1ø2" (34.29cm) Cut the duct as shown and keep portion A. TAB LOCATION Not for gas Bend tab up 45° Through the rear opening, locate the tab in the middle of the appliance base. Lift the tab to about 45°, using a flat-blade screwdriver. ADDING A NEW DUCT Fixing hole Portion "A" Left side exhaust Reconnect the cut portion (A) of the duct to the blower housing. Make sure that the shortened duct is aligned with the tab in the base. Use the screw saved previously to secure the duct in place through the tab on the appliance base. ADDING ELBOW AND DUCT FOR EXHAUST TO LEFT OR RIGHT SIDE OF CABINET Exhaust can be added to left or right (electric Duct models tape only) side • Preassemble 4" elbow with 4" duct. Wrap duct tape around joint. • ,QVHUWGXFWDVVHPEO\HOERZ¿UVWWKURXJKWKH side opening and connect the elbow to the dryer internal duct. Be sure not to pull or damage the electrical wires inside the dryer when inserting the duct. 15