GE GTL22JCPBS Owners Manual - Page 20

Installation Instructions REVERSING THE DOOR SWING (CONT.) 4 TRANSFER BOTTOM HINGE BRACKET TO THE LEFT Remove the base grille by pulling it straight out. Using a socket driver, move the bottom hinge bracket from the right side to the left side. NOTE: If the washer is not on the hinge bracket, check to see if it is stuck to the bottom of the door. 5 TRANSFER CENTER HINGE BRACKET TO THE LEFT Remove the center hinge bracket by removing the three screws. NOTE: Keep these screws with the hinge bracket. They are long screws and will be used when installing the hinge on the other side. You will need to remove the color-matched cap from the screw head before you can remove the screw. Use the edge of a thin flat blade to gently pry the caps off the screw heads. (A putty knife works well for this.) Cover the blade with tape to prevent scratching the paint. Remove the mullion cover from the left side using the thin flat blade. Assemble it to the right side. Remove the screw from the center left side of the cabinet. Screw it into the holes on the right side. Place the center hinge bracket over the holes at the center left side of the cabinet. Insert and tighten the three long screws. Replace the cap by snapping it over the screw with your finger. Mullion Cover Screw Cap 6 TRANSFER DOOR STOPS On each door, move the metal door stop from the right to the left. Move any screws from the left to the right. 20