GE IM4A Installation Instructions - Page 3
Installation Instructions, BEFORE YOU BEGIN - icemaker
UPC - 084691083207
View all GE IM4A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Installation Instructions BEFORE YOU BEGIN Read each step thoroughly before proceeding. • CAUTION - Unplug the Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet. TOOLS YOU WILL NEED Flat blade and Phillips Pliers screwdrivers Sharp knife 1 PREPARE FOR INSTALLATION • Remove the storage basket (on some models) by pulling it out to the stop position and lifting it up and out. Note: After removing the basket, push the extension arms back into the freezer compartment. • Remove the chiller shelf (on some models) by pulling it straight out. • Remove the ice bucket by pulling it out and lifting it up and out. • Remove the center vertical shelf support (on some models) by lifting it and rotating its bottom to the right. 1 PREPARE FOR INSTALLATION (cont.) • Inside the freezer, remove the two small white plug buttons (on some models) from the side wall. (If screws are present instead of plugs, leave them in place.) • Remove and discard the large white plug from the rear freezer Remove side wall plug buttons or leave screws in place Insulation plug wall. Pull out the gray insulation plug and remove any debris. • Remove the outlet Rear wall plug button cover with a flat-blade Outlet screwdriver. cover 2 INSTALL FILL TUBE • Slide the fill tube shipped with the refrigerator onto the water tube inlet (10). If the fill 10 tube has been misplaced, call 1.800.626.2002 and order part WR02X11712. • Go to the back of the refrigerator. Remove the label covering the hole. Pull out the insulation plug and any debris. • On the tube side of the water tube inlet (10), there is an adhesive backing. Remove the adhesive backing and slide the tube into the hole at the back of the refrigerator. Firmly press on the inlet to secure it to the refrigerator. 3 SET POWER SWITCH TO O (off) Set the icemaker power switch to O (off). Leave the power switch in the O (off) position until the refrigerator is connected to the water supply to prevent premature operation. Power Switch 3