GE JASRM24945 Instruction Manual - Page 10

FIND IT Locator Functions, cont. 3. Set the ITEM # for the Keyfob a. Remove the plastic tab from the battery compartment. The Keyfob beeps and immediately goes into setup mode. The LED blinks continuously to indicate that the Keyfob is ready to be set up. To enter the setup mode at any other time, press and hold the 1 and 3 buttons simultaneously for about 3 seconds. A warble beep is emitted and the LED flashes continuously. To Replace the Battery: • Open the battery compartment on the back. • Insert the battery with the "+" (positive) side up. • Close the battery compartment. FIND IT Locator Functions, cont. To set the ITEM # for the Keyfob: b. Enter setup mode as on the previous page (LED flashing continuously). c. Press a button (1 thru 6) to program the ITEM #. The Keyfob beeps the number of times corresponding to the ITEM #. Important, if you used the default code of #1 for your Remote's item #, then you will need to set your Keyfobs to something other than #1, i.e. 2 thru 6. If you purchase additional keyfobs then simply follow the steps above to set them up. Using the FIND IT Remote to Find Misplaced Items To find an object with a missing FIND IT Locator Keyfob attached, simply press FIND on your FIND IT Remote, the Remote warbles and the LED lights up, release FIND, then press the # key (1 thru 6) corresponding to the missing unit. If the object is in range, the FIND IT Locator Keyfob on the missing object will begin to flash and beep. You can use any Keyfob or Remote to locate any other Keyfob or Remote. The maximum distance the lost item can be from the Remote is about 30 ft. Therefore, it may be necessary to walk to various points in your home in order for it to function. The Keyfob beeps and immediately goes into setup mode. The LED flashes continuously to indicate that the Keyfob is ready to be set up. Please see Setting the ITEM # on the next page. 18 19