GE JVM1540LMCS Quick Specs - Page 2

GE Spacemaker, 5 Cu. Ft. Capacity Over-the-Range Microwave

Get GE JVM1540LMCS - 1.5cf Microwave 950W 300CFM 10LVL PDF manuals and user guides View all GE JVM1540LMCS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

JVM1540LMCS GE Spacemaker® 1.5 Cu. Ft. Capacity Over-the-Range Microwave Optional Accessories (Available at additional cost) Hood Exhaust Duct: Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully. Exhaust Duct: The hood exhaust has been designed to mate with a standard 3-1/4" x 10" rectangular duct. If a round duct is required, a rectangular-to-round transition adaptor must be used. Do not use less than a 6" diameter duct Rear Exhaust: If a rear or horizontal exhaust is to be used, care should be taken to align exhaust with space between studs, or wall should be prepared at the time it is constructed by leaving enough space between the wall studs to accommodate exhaust. Maximum Duct Length: For satisfactory air movement, the total duct length of 3-1/4" x 10" rectangular or 6" diameter round duct should not exceed 120 equivalent feet. Elbows, Transitions, Wall and Roof Caps, etc., present additional resistance to airflow and are equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total duct length, add the equivalent length of all transitions and adaptors plus the lengths of all straight duct sections. The chart below shows the approximate feet of equivalent length of some typical ducts. Filler Panel kits JX46BL When replacing a 36" range hood, this kit fills in the additional width to provide a custom built-in appearance. For installation between ­cabinets only; not for end-of-cabinet installation. Each kit ­contains two 3"-wide filler panels. Duct A. Rectangular-To-round Transition Adaptor B. Wall Cap C. 90° Elbow D. 45° Elbow E. 90° Elbow F. 45° Elbow G. Roof Cap Equivalent Feet 5 ft. 40 ft. 10 ft. 5 ft. 25 ft. 5 ft. 24 ft. For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. Filter kits JX81C- Recirculating Charcoal Filter kit To be used when the Spacemaker microwave oven cannot be vented to the outside. Listed by Underwriters Laboratories Specification Revised 8/07 340107

  • 1
  • 2
  • 3
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
®
service,
800.626.2000.
340107
Specification Revised 8/07
Listed by
Underwriters
Laboratories
JVM1540LMCS
GE Spacemaker
®
1.5 Cu. Ft. Capacity Over-the-Range Microwave
Optional Accessories (Available at additional cost)
Hood Exhaust Duct:
Outside ventilation requires a HOOD EXHAUST DUCT. Read the
following carefully.
Exhaust Duct:
The hood exhaust has been designed to mate with a standard
3-1/4" x 10" rectangular duct. If a round duct is required, a rectangular-to-round transition
adaptor must be used. Do not use less than a 6” diameter duct
Rear Exhaust:
If a rear or horizontal exhaust is to be used, care should be taken to
align exhaust with space between studs, or wall should be prepared at the time it is
constructed by leaving enough space between the wall studs to accommodate exhaust.
Maximum Duct Length:
For satisfactory air movement, the total
duct length of
3-1/4" x 10" rectangular or 6" diameter round duct should not exceed 120 equivalent feet.
Elbows, Transitions, Wall and Roof Caps,
etc., present additional resistance
to airflow and are equivalent to a section of straight duct which is longer than their
actual physical size. When calculating the total duct length, add the equivalent length of
all transitions and adaptors plus the lengths of all straight duct sections. The chart below
shows the approximate feet of equivalent length of some typical ducts.
Filter kits JX81C–
Recirculating
Charcoal Filter kit
To be used when
the Spacemaker
microwave oven
cannot be vented
to the outside.
Filler Panel kits
JX46BL
When replacing a
36"
range hood, this kit fills
in the additional width
to provide a custom
built-in appearance. For
installation between
cabinets only; not for
end-of-cabinet
installation. Each
kit contains two
3"-wide filler panels.
Duct
Equivalent Feet
A.
Rectangular-To-round
Transition Adaptor
5 ft.
B.
Wall Cap
40 ft.
C.
90° Elbow
10 ft.
D.
45° Elbow
5 ft.
E.
90° Elbow
25 ft.
F.
45° Elbow
5 ft.
G.
Roof Cap
24 ft.