GE JVM6175SKSS Installation Instructions - Page 17
Use Top Cabinet Template, Preparation Of Top Cabinet, Adapting Microwave, Blower For Outside Back,
View all GE JVM6175SKSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installation Instructions To use toggle bolts: Mounting Plate Spacing for Toggles More Than Wall Thickness Toggle Wings Toggle Bolt Wall Bolt End 3 Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. NOTE: Before tightening toggle bolts and wood screw, make sure the tabs on the mounting plate touch the bottom of the cabinet when pushed flush against the wall and that the plate is properly centered under the cabinet. CAUTION Be careful to avoid pinching fingers between the back of the mounting plate and the wall. 4 Tighten all bolts. Pull the plate away from the wall to help tighten the bolts. B3. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. B4. ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST 1 Remove and save screws that holds blower motor to microwave oven. Blower Retaining Screws Back of Microwave Oven 2 Open the blower door by lifting it up at the back of the microwave. Remove and save the blower shield on the back of the microwave by sliding it up. Remove and save the metal vent fan cover on the back of the microwave by sliding it up. 3 Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. BEFORE: Fan Blade Openings Facing Up End B End A • Read the instructions on the TOP CABINET TEMPLATE. • Tape it underneath the top cabinet. • Drill the holes, following the instructions on the TOP CABINET TEMPLATE. : CAUTION Wear safety goggles when drilling holes in the cabinet bottom. 4 Rotate blower unit counterclockwise 180°. Before Rotation After Rotation Back of Microwave Oven Back of Microwave Oven 17