GE NX-108E User Manual - Page 6

KEYPAD DISPLAY & LED'S Understanding the lights Armed Light Instant Light Fire Light Pull out zone ID Tab Zone Lights Ready Light Power Light Service Light Numeric code entry keys 5 function keys 3 emergency activation keys Armed Light Bypass Light Cancel Light Chime Light Exit Light Fire Light The armed light is "on" when the system is armed. The armed light is "off" when it is disarmed. The armed light will flash when there has been an alarm during the previous arm cycle. The bypass light is "on" when any zone in this keypad's partition is bypassed. If the bypass light is "off", no zones are bypassed. The cancel light will flash during an abort delay time. Entering a code followed by the [CANCEL] key during or after an alarm report to the central station will cause the cancel light to come on. It will stay on until the central station has received the cancel report. NOTE: The cancel feature must be enabled. (See "Cancel/Abort Feature") The chime light is "on" when the chime feature is "on"; "off" otherwise. The exit light is "on" during the exit delay. Please note that the light will flash during the last 10 seconds of the exit delay as a warning that the time is running out. (The user may want to disarm the system if the exit light is flashing in order to prevent an alarm. The user may then rearm the system and exit before the delay expires.) A steady fire light means a fire zone has been faulted. A rapidly flashing fire light means that a fire zone is in a trouble condition. NX-108/116/124E User manual Page 6 10/11/05