GE PB909 Installation Instructions - Page 1
GE PB909 - Profile: 30'' Electric Range Manual
View all GE PB909 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
ANTI-TIP BRACKET INSTALLATION INSTRUCTIONS WARNING • All ranges can tip. • BURNS or other SERIOUS INJURIES can result. • INSTALL and CHECK the ANTI-TIP bracket following the instructions supplied with the bracket. STEP 1 LOCATE THE BRACKET IMPORTANT: Determine the final location of the range before attempting to install the bracket. a. Place the bracket on the floor with the back edge against the rear wall. If the range does not reach the rear wall, align the back edge of the bracket with the rear panel of the range in its final location. To reduce the RISK OF TIPPING the range, the range must be secured by a properly installed ANTI-TIP BRACKET. Secure the bracket with the screws provided. NOTE: The installation of the ANTI-TIP bracket must meet all local codes for securing the appliance. If you did not receive an anti-tip bracket with your purchase, call 1-800-626-8774 to receive one at no cost. In Canada, call 1-800-561-3344. For installation instructions of the bracket, visit: GEAppliances.com. In Canada, GEAppliances.ca. STEP 2 SECURE THE BRACKET The bracket must be screwed to either the FLOOR or REAR WALL. Attachment to Floor or Rear Wall Bracket Screw must enter wood or concrete Wall Sill Plate Rear Wall Adjacent cabinet or final location of range side panel Loc C Loc A Loc B Two screws must enter floor or wall at Loc A, B or C. Screw must enter wood FLOOR Installation: WOOD FLOOR: Use the screws provided to secure the bracket using the pair of marked holes (either Loc A or B). CONCRETE FLOOR: Using a concrete bit, drill a 5/32" pilot hole 2" deep into the concrete at the center of each of the marked holes (either Loc A or B). Use the screws provided to secure the bracket into the floor. REAR WALL Installation: Use the 2 screws provided to secure the bracket using the pair of marked holes at Loc C. The screws MUST enter into a wood sill plate. If the wall contains any metal studs or similar materials, then the floor must be used. If bracket does not touch the rear wall, you MUST screw bracket to FLOOR as described in Step 2. b. Position the side of the bracket against either the left or right cabinet. If there is no adjacent cabinet, align the edge of the bracket with the side panel of the range in its final location. If the countertop overhangs the cabinet, offset the bracket from the cabinet by the amount of overhang. c. Mark the location for the pair of holes to be used (see illustration above). NOTE: For FLOOR installation use either Loc A or B. For REAR WALL installation use Loc C. 31-10671 04-08 JR STEP 3 CHECK THE BRACKET After installing the bracket, slide the range into its final location. The rear leveling leg must be fully inserted into the ANTI-TIP bracket. If the range has a storage drawer, remove the drawer and look underneath the range to see if the leg is fully engaged in the bracket as shown in Step 1. On models without storage drawer or kickpanel, verify the rear leveling leg is properly secured within the bracket by carefully tipping the range forward. DO NOT tip the range more than 4 inches. If the bracket does not stop the range within 4 inches, the bracket is NOT properly installed and MUST be reinstalled following these instructions. The anti-tip bracket must be PROPERLY INSTALLED and the rear leveling leg must be FULLY ENGAGED into the bracket to prevent the range from tipping. NEVER remove the leveling legs. This will prevent the range from being secured to the ANTI-TIP bracket properly.