GE PFSF6PKXBB Use and Care Manual - Page 26
Installing the Refrigerator, REFRIGERATOR LOCATION, CLEARANCES, REMOVING THE REFRIGERATOR DOORS
UPC - 084691172390
View all GE PFSF6PKXBB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Installation Instructions INSTALLING THE REFRIGERATOR REFRIGERATOR LOCATION • Do not install the refrigerator where the temperature will go below 60°F (16°C) because it will not run often enough to maintain proper temperatures. • Do not install the refrigerator where the temperature will go above 100°F (37°C) because it will not perform properly. • Install it on a floor strong enough to support it fully loaded. CLEARANCES Allow the following clearances for ease of installation, proper air circulation and plumbing and electrical connections. Sides 1/8″ (3 mm) Top 1″ (25 mm) Back 1″ (25 mm) REMOVING THE REFRIGERATOR DOORS • IMPORTANT NOTE: This refrigerator is 355/8″ deep. Doors and passageways leading to the installation location must be at least 36″ wide in order to leave the doors and handles attached to the refrigerator while transporting it into the installation location. If passageways are less than 36″, the refrigerator doors and handles can easily be scratched and damaged. The top cap and doors can be removed to allow the refrigerator to be safely moved indoors. If passageways are less then 31″, the leveling legs must be removed as well. Start with Step 1. • If it is not necessary to remove doors, skip to Step 11. Leave tape and all packaging on doors until the refrigerator is in the final location. • NOTE: Use a padded hand truck to move this refrigerator. Place the refrigerator on the hand truck with a side against the truck. We strongly recommend that TWO PEOPLE move and complete this installation. 1 REMOVE THE FRESH FOOD DOOR HANDLE Stainless steel: A REMOVING THE DOOR HANDLE: Loosen the set screws with the 3/32″ Allen wrench Badge and remove A the handle. Mounting Fasteners Plastic handle: A REMOVING THE DOOR HANDLE: Slide the handle up and off of the mounting Badge fasteners. A Mounting Fasteners NOTE: If the handle mounting fasteners need to be tightened or removed, use a Phillips-head screwdriver. 2 REMOVE THE FREEZER DOOR HANDLE Stainless steel and plastic handles: A Loosen the set screws located on the underside of the handle with the 1/8″ Allen wrench and remove the handle. NOTE: If the handle mounting fasteners need to be tightened or removed, use a Phillips-head screwdriver. A 26