GE PGS975DEPWW Use and Care Manual - Page 40
Problem, Possible Causes, What To
UPC - 084691199731
View all GE PGS975DEPWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions Before you call for service... Troubleshooting Tips Problem "F-and a number or letter" flash in the display Control signals after entering cooking time or start time Display goes blank Display flashes Unable to get the display to show "SF" "Probe" appears in the display Power outage, clock flashes Steam from the vent "Burning" or "oily" odor emitting from the vent Strong odor Fan noise LOC shows in the display 40 Possible Causes What To Do You have a function error code. • Touch the CLEAR/OFF pad. Put the oven back into operation. If the function code repeats. • Disconnect all power to the range for at least 30 seconds and then reconnect power. If the function error code repeats, call for service. You forgot to enter a bake temperature or cleaning time. • Touch the BAKE pad and desired temperature or the SELF CLEAN STD/LOW or SELF CLEAN LOW/STD pad and desired clean time. A fuse in your home may be blown or the circuit breaker tripped. The clock is in the black-out mode. • Replace the fuse or reset the circuit breaker. • See the Special features of your oven control section. Power failure. • Reset the clock. Oven control pads were not touched properly. • The BROIL HI/LO and BAKE pads must be touched at the same time and held for 3 seconds. This is reminding you to enter a probe temperature after plugging in the probe. • Enter a probe temperature. Power outage or surge. • Reset the clock. If the oven was in use, you must reset it by touching the CLEAR/OFF pad, setting the clock and resetting any cooking function. When using the convection • This is normal. feature, it is normal to see steam coming out of the oven vent. As the number of racks or amount of food being cooked increases, the amount of visible steam will increase. This is normal in a new oven • To speed the process, set a self-clean cycle for a and will disappear in time. minimum of 3 hours. See the Using the self-cleaning oven section. An odor from the insulation • This is temporary. around the inside of the oven is normal for the first few times the oven is used. A cooling fan or a convection • This is normal. The cooling fan will turn off and fan (depending on the on to cool internal parts. It may run after the oven is function you are using) may turned OFF. The convection fan will cycle on and off automatically turn on and off. until the function is over or the door is opened. The Range Lock-Out feature • Be sure the surface burner controls are turned OFF. is activated. Turn this feature off to use the range. See the Range Lock-Out section.