GE PSF23MGWCC Owners Manual - Page 30

Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions Before you call for service... Problem Ice cubes have odor/taste Small or hollow cubes Slow ice cube freezing Orange glow in the freezer Cube dispenser does not work (on some models) Water has poor taste/odor (on some models) Water in first glass is warm (on some models) Water dispenser does not work (on some models) Water spurting from dispenser (on some models) Water is not dispensed (on some models) but icemaker is working Possible Causes Ice storage bin needs cleaning. Food transmitting odor/taste to ice cubes. Interior of refrigerator needs cleaning. Water filter clogged. Door left open. Temperature control not set cold enough. Defrost heater is on. Icemaker turned off or water supply turned off. Ice cubes are frozen to icemaker feeler arm. An item is blocking or has fallen into the ice chute inside the top door bin of the freezer. Irregular ice clumps in storage container. Dispenser is LOCKED. Water dispenser has not been used for a long time. Normal when refrigerator is first installed. Water dispenser has not been used for a long time. Water system has been drained. Water supply line turned off or not connected. Water filter clogged. Air may be trapped in the water system. Dispenser is LOCKED. Newly-installed filter cartridge. Water in reservoir is frozen. Refrigerator control setting is too cold. What To Do • Empty and wash bin. Discard old cubes. • Wrap foods well. •See Care and cleaning. •Replace filter cartridge with new cartridge or with plug. • Check to see if package is holding door open. •See About the controls. • This is normal. • Turn on icemaker or water supply. • Remove cubes. • Remove any item that might be blocking, or has fallen into, the chute. • Break up with fingertip pressure and discard remaining clumps. •Freezer may be too warm. Adjust the freezer control to a colder setting, one position at a time, until clumps do not form. •Press and hold the LOCK pad for 3 seconds. •Dispense water until all water in system is replenished. • Wait 24 hours for the refrigerator to completely cool down. • Dispense water until all water in system is replenished. •Allow several hours for replenished supply to chill. • See Installing the water line. • Replace filter cartridge or remove filter and install plug. •Press the dispenser arm for at least two minutes. •Press and hold the LOCK pad for 3 seconds. •Run water from the dispenser for 3 minutes (about one and a half gallons). •Call for service. •Set to a warmer setting. 30