GE PTWN6250MWT Use and Care Manual - Page 6
About washer features. - parts
UPC - 084691226444
View all GE PTWN6250MWT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
About washer features. Safety Instructions Operating Instructions 1 Tab 2 3 4 SETTINGS OFF 2nd RINSE Set when adding FABRIC SOFTENER EXT. SPIN + AUTO SOAK EXTENDED SPIN AUTO SOAK +FA2BnRdICRISNOSFET&ENEXERTENDED SPI F+A2BnRdICRISNOSFETENER The Fabric Softener Dispenser (on some models) The fabric softener dispenser automatically releases liquid fabric softener at the proper time during the cycle. Do not stop the washer or raise the lid during the first spin. This will cause the dispenser to empty too soon. Never pour fabric softener directly on clothes. This may cause stains on your clothing. To use, follow these steps: 1 Lift the tab on the fabric softener dispenser top. 2 Measure out fabric softener into the cap and pour the softener into the dispenser top. The fabric softener will drain into the receiving cup inside the dispenser. Use only "Ultra" or concentrated fabric softeners. NOTE: Overfilling the dispenser will cause fabric softener to drain out of the holes in the side of the Infusor™ when filling. Do not overfill. 3 Push down on the tab to close the dispenser top. Make sure the tab is pushed down fully and snaps shut. 4 Select FABRIC SOFTENER from SETTINGS on the control panel. 1 3 5 6 6 Turning Tabs Turning Tabs Cleaning the Fabric Softener Dispenser (on some models) The Fabric Softener Dispenser is self cleaning. This dispenser does not require regular cleaning like standard fabric softener dispensers. Wipe down exterior surfaces of the dispenser as needed. If cleaning of the internal dispenser components is needed, follow these steps after the wash cycle is complete: 1 Lift the dispenser top tab and turn the top counterclockwise using the 2 turning tabs shown. Lift the dispenser out of the Infusor™. 2 Clean out any buildup from inside the Infusor™ with a soft cloth or toothbrush. Ensure the three rectangular holes in the bottom which allow the fabric softener to drain are not blocked. 3 Gently pull the cap away from the dispenser cup to separate. 4 Wipe surfaces with a soft cloth or soak the parts in a solution of 1 gallon warm water, 1/4 cup liquid detergent and 1 cup bleach. Ensure the small hole in the top surface of the cap and associated tube are not obstructed. 5 Reassemble the dispenser cup and cap by snapping them together. 6 Place the dispenser assembly into the Infusor™. Turn the top clockwise using the 2 turning tabs shown. Push down on the tab to close the dispenser top. Make sure the tab is pushed down fully and snaps shut. Troubleshooting Tips Consumer Support