GE PVM1790SRSS Quick Specs - Page 2

PVM1790DR/SR GE Profile™ 1.7 Cu. Ft. Capacity Over-the-Range Microwave Oven Optional Accessories (Available at additional cost) Hood Exhaust Duct: Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully. Exhaust Connection: The hood exhaust has been designed to mate with a standard 3-1/4" x 10" rectangular duct. If a round duct is required, a rectangular-to-round transition adaptor must be used. Do not use less than a 6" diameter duct. Rear Exhaust: If a rear or horizontal exhaust is to be used, care should be taken to align exhaust with space between studs, or wall should be prepared at the time it is constructed by leaving enough space between the wall studs to accommodate exhaust. Maximum Duct Length: For satisfactory air movement, the total duct length of 3-1/4" x 10" rectangular or 6" diameter round duct should not exceed 140 equivalent feet. ELBOWS, TRANSITIONS, WALL AND ROOF CAPS: etc., present additional resistance to airflow and are equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total duct length, add the equivalent length of all transitions and adaptors plus the lengths of all straight duct sections. The chart below shows the approximate feet of equivalent length of some typical ducts. Filler Panel Kits JX48BL-Black JX48WH-White When replacing a 36" or 42" range hood, this kit fills in the additional width to provide a custom built-in appearance. For installation between ­ cabinets only; not for end-of-cabinet installation. Each kit ­contains two 3"-wide filler panels. Duct Equivalent Feet A. Rectangular-To-round Transition Adaptor 5 ft. B. Wall Cap 40 ft. C. 90° Elbow 10 ft. D. 45° Elbow 5 ft. E. 90° Elbow 25 ft. F. 45° Elbow 5 ft. G. Roof Cap 24 ft. Filter Kits JX81D-Recirculating Charcoal Filter Kit To be used when the Spacemaker microwave oven cannot be vented to the outside. Specification Created 6/10 Listed by Underwriters Laboratories 240273